1
2
3
4
5
6
7
8
9
10 10
10
M
ULED
DLED LED
OFF LASER
V- V+
FLASH
FADE
SMOOTH
1. ON/OFF
2.Control de vi ce volume off
3.Night light and projector lamp bright ne ss adjustment
4. Motor speed adjustment
5. La se r light switch
6. Ni gh t lig ht a nd proj ectio n of f
7. Turn night light on
8. Turn projection light on
9. Tlnal keys(ligh ts foll ow m usi ca l rhyth m)
10. Projection Mode
Remote controlfunction instruction
31
2
4
5
6
9
10
11
12
13
7
14
8
11. Night light and main light color adjustment key
12. Short Press Next song
Long Press to Increase Volume
13. Short Press last song
Long Press to reduce vllume
14. Pause key
UFO Music Starry Projector
User Manual
Quick Start (avoid look steadily at LASER and Projector LED)
1.Use TypeC cable connect projector typeC port and USB power;
2.Long touch ON/OFF touch key until LED ON;
3.Mobile phone or Computer Bluetooth connect ”BT-UFLiSPK”
4.Select you like projector or light color mode
Key and Interface
1.ON/OFF Long touch 1 second ON or OFF
2.Projector mode Short touch switch 5 projector dynamic mode
*Rhythm of music mode *6 color jump *6 color flash *smooth *OFF
3.Night LED mode Short touch switch 5 color night LED color
*Orange *Cyan *Purple *OFF *White
Dimming Long touch switch night LED light mode60%--20%--100%
4.Motor Speed Short touch switch motor speed
*60% *100% *OFF *40%
Laser Starry Long touch switch ON/OFF Laser starry
5.NEXT / VOL- Short touch choose NEXT song
Long touch volume down
6.LAST / VOL+ Short touch choose LAST song
Long touch volume up
Touch key
Specifications
7.LASER STARRY 8.PROJECTOR LED
9.USB type C port 10.ROUND NIGHT LED
LED and Interface
Notice
Package list
Music starry projector *1pcs User manual * 1pcs USB cable * 1pcs
QY -U F001
2*1.5W M AX
<5m W
18 *0.2W M AX
Po we r Input US B DC 5V>1A
3. 7V 1 800mAh op ti onal
15 0* 95mm
En vi ronment T em peratur e 0- 40 C H umidity 0- 95%
Pr oj ection Co ve rage
100-40 0ft²(10-40m²)
Produc t Mod el
Pr oj ector LED
La se r starry
Ni gh t LED
Ba tt ery
Di me nsions
1.Built-in battery charging instructions:Please use the national
certification of the CCC adapter can output voltage 5V of electricity,
the battery voltage below 3V will automatically shut down.When
charging,the projection hood will be lit red,full of green light,full of
electricity for about 5hours.
2.Do not disassemble the product and battery.batteries are prohibited
from disassembling,hitting, squeezing or putting into fire;Do not
continue to use if severe swelling occurs;Do not place in a high
temperature environment.
3.This product for high-power LED and laser combination lamp
projection lamp,please do not look directly at the lamp and laser lamp,
if you feel uncomfortable please turn off immediately, do not let children
use this product alone.
4. In the ambient light strong light place to use this product will affect
the projection effect. It is recommended to use in a relatively dark
environment
5. It is recommended to use this product in indoor or in the car with a
roof lamp position,the ceiling height of more than 5 meters or no roof
outdoor environmental impact projection effect.
6.The light source of this product is not replaceable;When the light
source ends, replace the entire luminaire.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1)This device may not cause harmful interference .
(2) This device must accept any received,including interference that may cause
undesired operation.
2. Changes o r modifications not expressly approved by the party responsible
for compliance could void the userʼs auth o r i t y t o operate the equipment.
Note:This equipment has been tested and found to compl y with the limits for a
class B digital device,pursuant t o Part 15 of the F C C Rules.T h es e limits are
designed t o provide reasonable protection against harmful interference i n
a residential installation.
This equipment generates uses and can radiate radio frequence energy and,
if not installed and used in accordance with the instructions, m a y cause
harmful interference to radio communications.However,there is no guarantee
that interference will not occur i n a particular installation.if this equipment
does cause harmful interference to radio o r television reception,which c a n b e
determ i n e d b y t u rn i n g the equipment off and on, the user i s encouraged to try t o
correct the interfe r e n c e b y one or more o f the followi n g measures:
. Reorient o r r e l o ca t e the receiving antenna.
. Increase the separation b e t w e e n the equipment and receiver.
. Connect the equipme n t into an autlet o n a circuilt different from that t o which
the receiver is connected.
. Consult the dealer o r a n experienced radio/TV technician for help.
IC State m e n t
This d e v i c e contains licence-exempt transmitter(s) / receiver(s) that comply with
Innovation,Science and Economic Development Canadaʼs licence-exempt RSS(s).
Operation i s subject to the following two conditions:
1.This device may n o t cause interference.
2.This device must accept any interference,including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d’lndustrie Canada a p p li c a b l es auxappareils
radio exempts de licence.L’exploitation est autorisée aux d e u x conditions suivantes:
(1) I’appare i l n e doit pas produire de brouillage, et(2)I’utilisateur d e I’appareil
doit accepter toutbrouillage radioélectrique subi,même si le brouillage est susceptible
d’encomp r o m e t t re lefonctionnement.
CANICES-5(B)/NMB-5(B)
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1)This device may not cause harmful interference .
(2) This device must accept any received,including interference that may cause
undesired operation.
2. Changes o r modifications not expressly approved b y the party responsible
for compliance could void the userʼs authority to operate the equipment.
Note:This equipment has been tested and found to comply with the limits for a
class B digital device,pursuant t o Part 15 of the FCC Rules.These limits are
designed t o provide reasonable protection against harmful interference i n
a residential installation.
This equipment generates uses and can radiate radio frequence energy and,
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.However,there is no guarantee
that interference will not occur i n a particular installation.if this equipment
does cause harmful interference to radio o r television reception,which can be
determined b y turning the equipment off and on, the user is encouraged to try t o
correct the interference b y one or more o f the following measures:
. Reorient o r relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an autlet o n a circuilt different from that t o which
the receiver is connected.
. Consult the dealer o r a n experienced radio/TV technician for help.
针对便携式产品 Protable Equipment:
The device has been evaluated t o meet general R F exposure requirement.The devicecan
be used i n portable exposure condition without restriction.
针对移动式产品 Mobile Equipment:
The device has been evaluated to meet general RF exposure requirement,This equipment should be
installed and operated with a minumum distance of 20 cm between the radiator and your body.
IC Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation,Science and Economic Development Canadaʼs licence-exempt RSS(s) .
Operation i s subject to the following two conditions:
1.This device may not cause interference.
2.This device must accept any interference,including interference that may cause
undesired operation of the device.
This equipment should b e installed and operated with a minumum distance of 2 0 c m
between the radiator and you body.
Le présent appareil est conforme aux CNR d’lndustrie Canada applicables auxappareils
radio exempts de licence.L’exploitation est autorisée aux deux conditions suivantes:
(1) I’appareil n e doit pas produire de brouillage, et(2)I’utilisateur d e I’appareil
doit accepter toutbrouillage radioélectrique subi,même si le brouillage est susceptible
d’encompromettre lefonctionnement.
CANICES-5(B)/NMB-5(B)
Cet équipement doit êtr e installé et utilisé à u n e distance minimale d e 2 0 c m entre le
radiateur e t votre corps.
The device has been evaluated to meet general RF exposure requirement. The devicecan
be used in portable exposure condition without restriction.