2. Infinix
  3. X6826
X6826

Infinix X6826 User manual

  • Hello! I have reviewed the Infinix X6826 user manual and am ready to assist you. This document includes instructions on using your device, including details on its various components and how to install SIM cards, charge the device, and understand FCC compliance guidelines. I can answer specific questions about the phone's features, SAR information, or any other topic covered within the manual.
  • Can I use any charger to charge the phone?
    What is the SAR limit set by the FCC?
    What is the required separation distance for body-worn operation?
Infinix X6826
User Manual (N&K)
1
Explosion diagram specification
1
TP+LCM
2
LIGHT GUIDE FILM
3
FRONT HOUSING
4
FRONT CAMERA FRAME
5
8M CAMERA
6
CAMERA RUBBER
7
8W CAMERA
8
PROXIMITY SENSOR RUBBER
9
UP SPEAKER
10
50M CAMERA
11
FINGERPRINT
12
50M CAMERA
CONDUCTIVE_FOAM
13
MAIN BOARD
14
MAIN BOARD MYLAR
15
MAIN BOARD FRAME
16
SIM CONNECTOR
17
RECEIVER
CONDUCTIVE_FABRIC
18
8M CAMERA
CONDUCTIVE_FABRIC
19
LCM CONNECTOR RUBBER
20
BATTERY CONNECTOR
RUBBER
21
MIDDLE HOUSING
22
MYLAR
23
3.5 SCREW
24
2.5 SCREW
25
BATTERY COVER
26
50M CAM LENS
27
8W CAM LENS
28
HEAT DISSIPATION COPPER
FOIL
29
HEAT DISSIPATION FILM
30
USB RUBBER
2
31
AUDIO JACK RUBBER
32
MOTOR
33
SIDE KEY FPC
34
DOWN SPEAKER
35
BATTERY
36
SUB BOARD
37
COAXIAL CABLE
3
Know your phone
1. Front camera
2. Volume + key
3. Volume - key
4. Power key & side fingerprint sensor
2
SIM/SD card installation
1.
1. Power
Power off
off mobile.
mobile.
2.
2. Refer
Refer to
to the
the following
following picture
picture for
for SIM
SIM /
/SD
SD card
card
installation.
installation.
3
Charging
Charging the
the phone
phone
You
You can
can charge
charge your
your device
device using
using a
acharger
charger or
or by
by connecting
connecting
it
it to
to the
the computer
computer using
using a
aUSB
USB cable
cable (comes
(comes with
with the
the
phone).
phone).
Use
Use only
only INFINIX
INFINIX charger
charger and
and cables.
cables. Other
Other chargers
chargers or
or
cables
cables may
may damage
damage the
the device.
device. This
This will
will invalidate
invalidate your
your
phone
phone warranty.
warranty.
4
FCC
FCC Statement
Statement
1.
1. This
This device
device complies
complies with
with Part
Part 15
15 of
of the
the FCC
FCC Rules.
Rules.
Operation
Operation is
is subject
subject to
to the
the following
following two
two conditions:
conditions:
(1)
(1) This
This device
device may
may not
not cause
cause harmful
harmful interference.
interference.
(2)
(2) This
This device
device must
must accept
accept any
any interference
interference received,
received,
including
including interference
interference that
that may
may cause
cause undesired
undesired
operation.
operation.
2.
2. Changes
Changes or
or modifications
modifications not
not expressly
expressly approved
approved by
by the
the
party
party responsible
responsible for
for compliance
compliance could
could void
void the
the user's
user's
authority
authority to
to operate
operate the
the equipment.
equipment.
NOTE:
NOTE:
This
This equipment
equipment has
has been
been tested
tested and
and found
found to
to comply
comply with
with
the
the limits
limits for
for a
aClass
Class B
Bdigital
digital device,
device, pursuant
pursuant to
to Part
Part 15
15
of
of the
the FCC
FCC Rules.
Rules. These
These limits
limits are
are designed
designed to
to provide
provide
reasonable
reasonable protection
protection against
against harmful
harmful interference
interference in
in a
a
residential
residential installation.
installation.
This
This equipment
equipment generates
generates uses
uses and
and can
can radiate
radiate radio
radio
frequency
frequency energy
energy and,
and, if
if not
not installed
installed and
and used
used in
in
accordance
accordance with
with the
the instructions,
instructions, may
may cause
cause harmful
harmful
interference
interference to
to radio
radio communications.
communications. However,
However, there
there is
is
no
no guarantee
guarantee that
that interference
interference will
will not
not occur
occur in
in a
a
particular
particular installation.
installation. If
If this
this equipment
equipment does
does cause
cause
harmful
harmful interference
interference to
to radio
radio or
or television
television reception,
reception,
which
which can
can be
be determined
determined by
by turning
turning the
the equipment
equipment off
off
and
and on,
on, the
the user
user is
is encouraged
encouraged to
to try
try to
to correct
correct the
the
interference
interference by
by one
one or
or more
more of
of the
the following
following measures:
measures:
Reorient
Reorient or
or relocate
relocate the
the receiving
receiving antenna.
antenna.
5
Increase
Increase the
the separation
separation between
between the
the equipment
equipment and
and
receiver.
receiver.
Connect
Connect the
the equipment
equipment into
into an
an outlet
outlet on
on a
acircuit
circuit
different
different from
from that
that to
to which
which the
the receiver
receiver is
is connected.
connected.
Consult
Consult the
the dealer
dealer or
or an
an experienced
experienced radio/TV
radio/TV technician
technician
for
for help.
help.
SAR
SAR Information
Information Statement
Statement
Your
Your wireless
wireless phone
phone is
is a
aradio
radio transmitter
transmitter and
and receiver.
receiver. It
It
is
is designed
designed and
and manufactured
manufactured not
not to
to exceed
exceed the
the emission
emission
limits
limits for
for exposure
exposure to
to radiofrequency
radiofrequency (RF)
(RF) energy
energy set
set by
by
the
the Federal
Federal Communications
Communications Commission
Commission of
of the
the U.S.
U.S.
Government.
Government. These
These limits
limits are
are part
part of
of comprehensive
comprehensive
guidelines
guidelines and
and establish
establish permitted
permitted levels
levels of
of RF
RF energy
energy for
for
the
the general
general population.
population. The
The guidelines
guidelines are
are based
based on
on
standards
standards that
that were
were developed
developed by
by independent
independent scientific
scientific
organizations
organizations through
through periodic
periodic and
and thorough
thorough evaluation
evaluation
of
of scientific
scientific studies.
studies. The
The standards
standards include
include a
asubstantial
substantial
safety
safety margin
margin designed
designed to
to assure
assure the
the safety
safety of
of all
all persons,
persons,
regardless
regardless of
of age
age and
and health.
health. The
The exposure
exposure standard
standard for
for
wireless
wireless mobile
mobile phones
phones employs
employs a
aunit
unit of
of measurement
measurement
known
known as
as the
the Specific
Specific Absorption
Absorption Rate,
Rate, or
or SAR.
SAR. The
The SAR
SAR
limit
limit set
set by
by the
the FCC
FCC is
is 1.6
1.6 W/kg.
W/kg. *
*Tests
Tests for
for SAR
SAR are
are
conducted
conducted with
with the
the phone
phone transmitting
transmitting at
at its
its highest
highest
certified
certified power
power level
level in
in all
all tested
tested frequency
frequency bands.
bands.
Although
Although the
the SAR
SAR is
is determined
determined at
at the
the highest
highest certified
certified
power
power level,
level, the
the actual
actual SAR
SAR level
level of
of the
the phone
phone while
while
operating
operating can
can be
be well
well below
below the
the maximum
maximum value.
value. This
This is
is
6
because
because the
the phone
phone is
is designed
designed to
to operate
operate at
at multiple
multiple
power
power levels
levels so
so as
as to
to use
use only
only the
the power
power required
required to
to reach
reach
the
the network.
network. In
In general,
general, the
the closer
closer you
you are
are to
to a
awireless
wireless
base
base station
station antenna,
antenna, the
the lower
lower the
the power
power output.
output. Before
Before
a
aphone
phone model
model is
is available
available for
for sale
sale to
to the
the public,
public, it
it must
must
be
be tested
tested and
and certified
certified to
to the
the FCC
FCC that
that it
it does
does not
not exceed
exceed
the
the limit
limit established
established by
by the
the government
government adopted
adopted
requirement
requirement for
for safe
safe exposure.
exposure. The
The tests
tests are
are performed
performed in
in
positions
positions and
and locations
locations (e.g.,
(e.g., at
at the
the ear
ear and
and worn
worn on
on the
the
body)
body) as
as required
required by
by the
the FCC
FCC for
for each
each model.
model. The
The highest
highest
SAR
SAR value
value for
for this
this model
model phone
phone when
when tested
tested for
for use
use at
at the
the
ear
ear is
is 0.743W/Kg
0.743W/Kg and
and when
when worn
worn on
on the
the body,
body, as
as
described
described in
in this
this user
user guide,
guide, is
is 0.362W/Kg
0.362W/Kg (Body-worn
(Body-worn
measurements
measurements differ
differ among
among phone
phone models,
models, depending
depending
upon
upon available
available accessories
accessories and
and FCC
FCC requirements).
requirements). The
The
maximum
maximum scaled
scaled SAR
SAR in
in hotspot
hotspot mode
mode is
is 0.439W/Kg.
0.439W/Kg.
While
While there
there may
may be
be differences
differences between
between the
the SAR
SAR levels
levels
of
of various
various phones
phones and
and at
at various
various positions,
positions, they
they all
all meet
meet
the
the government
government requirement
requirement for
for safe
safe exposure.
exposure. The
The FCC
FCC
has
has granted
granted an
an Equipment
Equipment Authorization
Authorization for
for this
this model
model
phone
phone with
with all
all reported
reported SAR
SAR levels
levels evaluated
evaluated as
as in
in
compliance
compliance with
with the
the FCC
FCC RFexposure
RFexposure guidelines.
guidelines. SAR
SAR
information
information on
on this
this model
model phone
phone is
is on
on file
file with
with the
the FCC
FCC
and
and can
can be
be found
found under
under the
the Display
Display Grant
Grant section
section of
of
http://www.fcc.gov/
http://www.fcc.gov/ oet/fccid
oet/fccid after
after searching
searching on
on
FCC
FCC ID:
ID: 2AIZN-X6826
2AIZN-X6826 Additional
Additional information
information on
on
Specific
Specific Absorption
Absorption Rates
Rates (SAR)
(SAR) can
can be
be found
found on
on the
the
Cellular
Cellular Telecommunications
Telecommunications Industry
Industry Asso-ciation
Asso-ciation
(CTIA)
(CTIA) web-site
web-site at
at http://www.wow-com.com.
http://www.wow-com.com. *
*In
In the
the
7
United
United States
States and
and Canada,
Canada, the
the SAR
SAR limit
limit for
for mobile
mobile
phones
phones used
used by
by the
the public
public is
is 1.6
1.6 watts/kg
watts/kg (W/kg)
(W/kg) averaged
averaged
over
over one
one gram
gram of
of tissue.
tissue. The
The standard
standard incorporates
incorporates a
a
sub-stantial
sub-stantial margin
margin of
of safety
safety to
to give
give additional
additional protection
protection
for
for the
the public
public and
and to
to account
account for
for any
any variations
variations in
in
measurements.
measurements.
Body-worn
Body-worn Operation
Operation
This
This device
device was
was tested
tested for
for typical
typical body-worn
body-worn operations.
operations.
To
To comply
comply with
with RF
RF exposure
exposure requirements,
requirements, a
aminimum
minimum
separation
separation distance
distance of
of 10mm
10mm must
must be
be maintained
maintained between
between
the
the user
user’
’s
sbody
body and
and the
the handset,
handset, including
including the
the antenna.
antenna.
Third-party
Third-party belt-clips,
belt-clips, holsters,
holsters, and
and similar
similar accessories
accessories
used
used by
by this
this device
device should
should not
not contain
contain any
any metallic
metallic
components.
components. Body-worn
Body-worn accessories
accessories that
that do
do not
not meet
meet
these
these requirements
requirements may
may not
not comply
comply with
with RF
RF exposure
exposure
requirements
requirements and
and should
should be
be avoided.
avoided. Use
Use only
only the
the
supplied
supplied or
or an
an approved
approved antenna.
antenna.
8
For DTS patents, see http://patents.dts.com. Manufactured under license
from DTS Licensing Limited. DTS, the Symbol, & DTS and the Symbol
together are registered trademarks or trademarks of DTS, Inc. in the
United States and/or other countries. © DTS, Inc. All Rights Reserved.
Operating System：AndroidTM
Android is a trademark of Google LLC.
/