Infinix X6826 User manual

Infinix X6826

User Manual (N&K)

Explosion diagram specification

TP+LCM

LIGHT GUIDE FILM

FRONT HOUSING

FRONT CAMERA FRAME

8M CAMERA

CAMERA RUBBER

8W CAMERA

PROXIMITY SENSOR RUBBER

UP SPEAKER

50M CAMERA

FINGERPRINT

50M CAMERA

CONDUCTIVE_FOAM

MAIN BOARD

MAIN BOARD MYLAR

MAIN BOARD FRAME

SIM CONNECTOR

RECEIVER

CONDUCTIVE_FABRIC

8M CAMERA

CONDUCTIVE_FABRIC

LCM CONNECTOR RUBBER

BATTERY CONNECTOR

RUBBER

MIDDLE HOUSING

MYLAR

3.5 SCREW

2.5 SCREW

BATTERY COVER

50M CAM LENS

8W CAM LENS

HEAT DISSIPATION COPPER

FOIL

HEAT DISSIPATION FILM

USB RUBBER

AUDIO JACK RUBBER

MOTOR

SIDE KEY FPC

DOWN SPEAKER

BATTERY

SUB BOARD

COAXIAL CABLE

Know your phone

1. Front camera

2. Volume + key

3. Volume - key

4. Power key & side fingerprint sensor

SIM/SD card installation

1. Power

Power off

off mobile.

mobile.

2. Refer

Refer to

to the

the following

following picture

picture for

for SIM

SIM /

/SD

SD card

card

installation.

Charging

Charging the

the phone

phone

You

You can

can charge

charge your

your device

device using

using a

acharger

charger or

or by

by connecting

connecting

it to

to the

the computer

computer using

using a

aUSB

USB cable

cable (comes

(comes with

with the

the

phone).

Use

Use only

only INFINIX

INFINIX charger

charger and

and cables.

cables. Other

Other chargers

chargers or

cables

cables may

may damage

damage the

the device.

device. This

This will

will invalidate

invalidate your

your

phone

phone warranty.

warranty.

FCC

FCC Statement

Statement

1. This

This device

device complies

complies with

with Part

Part 15

15 of

of the

the FCC

FCC Rules.

Rules.

Operation

Operation is

is subject

subject to

to the

the following

following two

two conditions:

conditions:

(1)

(1) This

This device

device may

may not

not cause

cause harmful

harmful interference.

interference.

(2)

(2) This

This device

device must

must accept

accept any

any interference

interference received,

received,

including

including interference

interference that

that may

may cause

cause undesired

undesired

operation.

2. Changes

Changes or

or modifications

modifications not

not expressly

expressly approved

approved by

by the

the

party

party responsible

responsible for

for compliance

compliance could

could void

void the

the user's

user's

authority

authority to

to operate

operate the

the equipment.

equipment.

NOTE:

This

This equipment

equipment has

has been

been tested

tested and

and found

found to

to comply

comply with

with

the

the limits

limits for

for a

aClass

Class B

Bdigital

digital device,

device, pursuant

pursuant to

to Part

Part 15

of the

the FCC

FCC Rules.

Rules. These

These limits

limits are

are designed

designed to

to provide

provide

reasonable

reasonable protection

protection against

against harmful

harmful interference

interference in

in a

residential

residential installation.

installation.

This

This equipment

equipment generates

generates uses

uses and

and can

can radiate

radiate radio

radio

frequency

frequency energy

energy and,

and, if

if not

not installed

installed and

and used

used in

accordance

accordance with

with the

the instructions,

instructions, may

may cause

cause harmful

harmful

interference

interference to

to radio

radio communications.

communications. However,

However, there

there is

no guarantee

guarantee that

that interference

interference will

will not

not occur

occur in

in a

particular

particular installation.

installation. If

If this

this equipment

equipment does

does cause

cause

harmful

harmful interference

interference to

to radio

radio or

or television

television reception,

reception,

which

which can

can be

be determined

determined by

by turning

turning the

the equipment

equipment off

off

and

and on,

on, the

the user

user is

is encouraged

encouraged to

to try

try to

to correct

correct the

the

interference

interference by

by one

one or

or more

more of

of the

the following

following measures:

measures:

Reorient

Reorient or

or relocate

relocate the

the receiving

receiving antenna.

antenna.

Increase

Increase the

the separation

separation between

between the

the equipment

equipment and

and

receiver.

Connect

Connect the

the equipment

equipment into

into an

an outlet

outlet on

on a

acircuit

circuit

different

different from

from that

that to

to which

which the

the receiver

receiver is

is connected.

connected.

Consult

Consult the

the dealer

dealer or

or an

an experienced

experienced radio/TV

radio/TV technician

technician

for

for help.

help.

SAR

SAR Information

Information Statement

Statement

Your

Your wireless

wireless phone

phone is

is a

aradio

radio transmitter

transmitter and

and receiver.

receiver. It

is designed

designed and

and manufactured

manufactured not

not to

to exceed

exceed the

the emission

emission

limits

limits for

for exposure

exposure to

to radiofrequency

radiofrequency (RF)

(RF) energy

energy set

set by

the

the Federal

Federal Communications

Communications Commission

Commission of

of the

the U.S.

U.S.

Government.

Government. These

These limits

limits are

are part

part of

of comprehensive

comprehensive

guidelines

guidelines and

and establish

establish permitted

permitted levels

levels of

of RF

RF energy

energy for

for

the

the general

general population.

population. The

The guidelines

guidelines are

are based

based on

standards

standards that

that were

were developed

developed by

by independent

independent scientific

scientific

organizations

organizations through

through periodic

periodic and

and thorough

thorough evaluation

evaluation

of scientific

scientific studies.

studies. The

The standards

standards include

include a

asubstantial

substantial

safety

safety margin

margin designed

designed to

to assure

assure the

the safety

safety of

of all

all persons,

persons,

regardless

regardless of

of age

age and

and health.

health. The

The exposure

exposure standard

standard for

for

wireless

wireless mobile

mobile phones

phones employs

employs a

aunit

unit of

of measurement

measurement

known

known as

as the

the Specific

Specific Absorption

Absorption Rate,

Rate, or

or SAR.

SAR. The

The SAR

SAR

limit

limit set

set by

by the

the FCC

FCC is

is 1.6

1.6 W/kg.

W/kg. *

*Tests

Tests for

for SAR

SAR are

are

conducted

conducted with

with the

the phone

phone transmitting

transmitting at

at its

its highest

highest

certified

certified power

power level

level in

in all

all tested

tested frequency

frequency bands.

bands.

Although

Although the

the SAR

SAR is

is determined

determined at

at the

the highest

highest certified

certified

power

power level,

level, the

the actual

actual SAR

SAR level

level of

of the

the phone

phone while

while

operating

operating can

can be

be well

well below

below the

the maximum

maximum value.

value. This

This is

because

because the

the phone

phone is

is designed

designed to

to operate

operate at

at multiple

multiple

power

power levels

levels so

so as

as to

to use

use only

only the

the power

power required

required to

to reach

reach

the

the network.

network. In

In general,

general, the

the closer

closer you

you are

are to

to a

awireless

wireless

base

base station

station antenna,

antenna, the

the lower

lower the

the power

power output.

output. Before

Before

aphone

phone model

model is

is available

available for

for sale

sale to

to the

the public,

public, it

it must

must

be tested

tested and

and certified

certified to

to the

the FCC

FCC that

that it

it does

does not

not exceed

exceed

the

the limit

limit established

established by

by the

the government

government adopted

adopted

requirement

requirement for

for safe

safe exposure.

exposure. The

The tests

tests are

are performed

performed in

positions

positions and

and locations

locations (e.g.,

(e.g., at

at the

the ear

ear and

and worn

worn on

on the

the

body)

body) as

as required

required by

by the

the FCC

FCC for

for each

each model.

model. The

The highest

highest

SAR

SAR value

value for

for this

this model

model phone

phone when

when tested

tested for

for use

use at

at the

the

ear

ear is

is 0.743W/Kg

0.743W/Kg and

and when

when worn

worn on

on the

the body,

body, as

described

described in

in this

this user

user guide,

guide, is

is 0.362W/Kg

0.362W/Kg (Body-worn

(Body-worn

measurements

measurements differ

differ among

among phone

phone models,

models, depending

depending

upon

upon available

available accessories

accessories and

and FCC

FCC requirements).

requirements). The

The

maximum

maximum scaled

scaled SAR

SAR in

in hotspot

hotspot mode

mode is

is 0.439W/Kg.

0.439W/Kg.

While

While there

there may

may be

be differences

differences between

between the

the SAR

SAR levels

levels

of various

various phones

phones and

and at

at various

various positions,

positions, they

they all

all meet

meet

the

the government

government requirement

requirement for

for safe

safe exposure.

exposure. The

The FCC

FCC

has

has granted

granted an

an Equipment

Equipment Authorization

Authorization for

for this

this model

model

phone

phone with

with all

all reported

reported SAR

SAR levels

levels evaluated

evaluated as

as in

compliance

compliance with

with the

the FCC

FCC RFexposure

RFexposure guidelines.

guidelines. SAR

SAR

information

information on

on this

this model

model phone

phone is

is on

on file

file with

with the

the FCC

FCC

and

and can

can be

be found

found under

under the

the Display

Display Grant

Grant section

section of

http://www.fcc.gov/

http://www.fcc.gov/ oet/fccid

oet/fccid after

after searching

searching on

FCC

FCC ID:

ID: 2AIZN-X6826

2AIZN-X6826 Additional

Additional information

information on

Specific

Specific Absorption

Absorption Rates

Rates (SAR)

(SAR) can

can be

be found

found on

on the

the

Cellular

Cellular Telecommunications

Telecommunications Industry

Industry Asso-ciation

Asso-ciation

(CTIA)

(CTIA) web-site

web-site at

at http://www.wow-com.com.

http://www.wow-com.com. *

*In

In the

the

United

United States

States and

and Canada,

Canada, the

the SAR

SAR limit

limit for

for mobile

mobile

phones

phones used

used by

by the

the public

public is

is 1.6

1.6 watts/kg

watts/kg (W/kg)

(W/kg) averaged

averaged

over

over one

one gram

gram of

of tissue.

tissue. The

The standard

standard incorporates

incorporates a

sub-stantial

sub-stantial margin

margin of

of safety

safety to

to give

give additional

additional protection

protection

for

for the

the public

public and

and to

to account

account for

for any

any variations

variations in

measurements.

Body-worn

Body-worn Operation

Operation

This

This device

device was

was tested

tested for

for typical

typical body-worn

body-worn operations.

operations.

To comply

comply with

with RF

RF exposure

exposure requirements,

requirements, a

aminimum

minimum

separation

separation distance

distance of

of 10mm

10mm must

must be

be maintained

maintained between

between

the

the user

user’

’s

sbody

body and

and the

the handset,

handset, including

including the

the antenna.

antenna.

Third-party

Third-party belt-clips,

belt-clips, holsters,

holsters, and

and similar

similar accessories

accessories

used

used by

by this

this device

device should

should not

not contain

contain any

any metallic

metallic

components.

components. Body-worn

Body-worn accessories

accessories that

that do

do not

not meet

meet

these

these requirements

requirements may

may not

not comply

comply with

with RF

RF exposure

exposure

requirements

requirements and

and should

should be

be avoided.

avoided. Use

Use only

only the

the

supplied

supplied or

or an

an approved

approved antenna.

antenna.

For DTS patents, see http://patents.dts.com. Manufactured under license

from DTS Licensing Limited. DTS, the Symbol, & DTS and the Symbol

together are registered trademarks or trademarks of DTS, Inc. in the

Operating System：AndroidTM

Android is a trademark of Google LLC.

Infinix X6826 User manual

Related papers

Other documents