2. spezial electronic
  3. LVIV-B2

spezial electronic LVIV-B2 User manual

  • Hello! I've reviewed the Integration Manual for the LVIV-B2 Bluetooth Module Family. This manual provides important guidelines for integrating these modules, covering both external and internal antenna options. I can answer questions regarding module placement, antenna usage, metal enclosure restrictions, and clearance requirements, as mentioned in the document. Please feel free to ask!
  • Can the LVIV-B2 module be mounted in any way?
    What should be used if a metal enclosure is required?
    Where can the LVIV-B2 modules with U.FL connector for external antennas be placed?
    Can the unit with internal antenna be mounted in a metal enclosure?
    What is the minimum clearance between the antenna and the casing for internal antenna module?
©2022 by SE Spezial-Electronic GmbH
lviv-b2_module_family_integration_manual.docx - page 1/3
foraita, peter
LVIV-B2 Bluetooth Module Family
Integration Manual
LVIV-B2 cannot be mounted arbitrary, because of the radio communication.
If a metal enclosure is required, one of the external antenna options has to be used.
Module variants with U.FL connector for external antenna
- SE-NOBS-B2X-A3
- SE-NOBS-B2X-B3
Module Placement:
LVIV-B2 modules with U.FL connector for external antennas can be placed anywhere on
the PCB.
Suitable and certified external antennas and adapter cables are listed in the LVIV-B2
Data Sheet as well as in a separate document
“LVIVC-B2_module_family_certified_antennas.pdf”
©2022 by SE Spezial-Electronic GmbH
lviv-b2_module_family_integration_manual.docx - page 2/3
foraita, peter
Module variants with internal antenna
- SE-NOBS-B2i-A3
- SE-NOBS-B2i-B3
Module Placement:
The unit with an internal surface mounted antenna (SE-NOBS-B2i-**) cannot be
mounted in a metal enclosure.
No metal casing or plastics using metal flakes should be used, avoid also metallic based
paint or lacquer.
Keep a minimum clearance of 5 mm between the antenna and the casing.
Keep minimum 10 mm free space from metal around the antenna including under and
above.
LVIV-B2 modules with internal antenna must be placed on the edge of the PCB. At least
the specified region beneath the internal antenna must be free from any copper in all
layers (except for LVIV-B2 SMT pads on the Top Layer).
©2022 by SE Spezial-Electronic GmbH
lviv-b2_module_family_integration_manual.docx - page 3/3
foraita, peter
Example of a layout:
/