ENGLISH

Specifications

Model DC10WB

Input.......................................................................................................................................................... A.C. only 50 Hz – 60 Hz

Output ...............................................................................................................................................D.C. 7.2 V – 10.8 V/12 V max

Weight..................................................................................................................................................................0.32 kg (0.72 lbs)

• Weight according to EPTA-Procedure 01/2003.

safety and operating instructions for battery charger.

6. Do not charge the battery cartridge in presence of flammable liquids or gases.

7. Do not expose charger to rain or snow.

9. After charging or before attempting any maintenance or cleaning, unplug the charger from the power source. Pull by plug

rather than cord whenever disconnecting charger.

10. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.

11. Do not operate charger with damaged cord or plug – replace them immediately.

12. Do not operate or disassemble charger if it has received a sharp blow, been dropped, or otherwise damaged in any way;

13. The battery charger is not intended for use by young children or infirm persons without supervision.

respective markings on the charger.

3. When the battery cartridge is inserted fully, the charging light will change from green to red and charging will begin. The

4. When the charging light changes from red to green, the charging cycle is complete.

5. After charging, unplug the charger from the power source.

Refer to the table for the charging time below.

• The battery charger is for charging Makita battery cartridge. Never use it for other purposes or for other manufacturer’s batter-

• If charging light may flash in red color, battery condition is as below and charging may not start.