the great outdoors by Minka Lavery 8267-66-L Installation guide

Type
Installation guide

The great outdoors by Minka Lavery 8267-66-L is a versatile and stylish outdoor lighting fixture that is perfect for illuminating your home's exterior. With its sturdy construction and weather-resistant finish, this fixture is built to withstand the elements and provide years of reliable use. The 8267-66-L features a unique design that combines a circular back plate with two curved arms that extend outwards and support the light fixture. This design not only creates a visually appealing look, but also provides ample illumination for your outdoor space.

The great outdoors by Minka Lavery 8267-66-L is a versatile and stylish outdoor lighting fixture that is perfect for illuminating your home's exterior. With its sturdy construction and weather-resistant finish, this fixture is built to withstand the elements and provide years of reliable use. The 8267-66-L features a unique design that combines a circular back plate with two curved arms that extend outwards and support the light fixture. This design not only creates a visually appealing look, but also provides ample illumination for your outdoor space.

INSTALLATION INSTRUCTIONS
Model # 8267-L
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
PREPARING FOR INSTALLATION (Fig. 1
)
1. Shut off power at the circuit breaker and remove the old
fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts
in a clear area. Take care not to misplace any small parts
necessary for installation.
3. Thread the two studs (B) into the pre-drilled holes in the
circular strap (C) spaced the same distance apart as the
holes in the back plate.
4. Attach the circular strap (C) using outlet box screws (F) to
the outlet box (A) (not supplied),
the side of the marked
"GND" must face out (Fig 1).
CONNECTING THE WIRES (Fig. 2)
5. Connect the electrical wires as shown in Fig.2. Making
sure that all wire connectors are secured. If your outlet
box has a ground wire (green or bare copper), connect
the fixture’s ground wire to it. Otherwise, connect the
fixture’s ground wire directly to the cross bar using the
green screw (D) provided.
FINISHING THE INSTALLATION (Fig. 1)
6. Align the back plate onto studs (B) and secure with cap
nut (G) (Fig 1).
7. To prevent moisture from entering the outlet box (A) (not
supplied) and causing a short, use clear silicone sealant
to outline the outside of fixture back plate where it meets
the wall leaving a space at bottom to allow moisture a
means to escape (Fig. 3)
8. Install glass panels (P) via the bottom of the cage (J) and
secure with the glass clips provided.
9. Bulb (H) information (1 x AC LED 10W included.)
(DO NOT EXCEED THE MAXIMUM WATTAGE
RATING)
(NE PAS DEPASSER LA PUISSANCE
NOMINALE MAXIMALE!)
10.
Replacing LED module (Fig.4)
11.
The LED module can be replaced by a qualified
electrician without cutting of wire and without damage to any
decorative element to which the fixture is attached. See
installation steps for more details (Fig.4).
a. Shut off power, take out and unplug the male and female
jacket M&N via the bottom of the cage (J).
b.
b. Loosening module screws (I) and carefully remove LED
module (H) for re-lamping. Note: The LED module should
be provided by a specified supplier.
c. For better heat dissipation the LED module (H) should be
installed with the heat transfer material (O) when re-
lamping.
Your installation is now complete. Return power to the
outlet box and test the fixture.
Note: Illustration (Fig.1) on this manual is for
installatio
n purposes only. It may or may not be
Fig.1
P
D
F
B
C
E
A
G
H
I
J
Fig.2
Fig. 3
Caulking
Backplate
Fig. 4
Al
H
I
K
L
M
N
O
  • Page 1 1

the great outdoors by Minka Lavery 8267-66-L Installation guide

Type
Installation guide

The great outdoors by Minka Lavery 8267-66-L is a versatile and stylish outdoor lighting fixture that is perfect for illuminating your home's exterior. With its sturdy construction and weather-resistant finish, this fixture is built to withstand the elements and provide years of reliable use. The 8267-66-L features a unique design that combines a circular back plate with two curved arms that extend outwards and support the light fixture. This design not only creates a visually appealing look, but also provides ample illumination for your outdoor space.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI