Installation
i
Caution: During the following step, hold unit firmly until window sash
is lowered to top channel behind side _nel frames. Per_nal injury or
property damage may result if unff falls from window.
2_
Open the window, MaA a line on
_nter of'the window stool(or desired
air conditioner location),
Carefuffy place the cabinet on the
window stool and align the _nter
mark on the bottom fro,nt wi#_ the
center line marked in the window
stool,
Pull the bottom window sash down
behind the upper guide until it meets.
:Do not pul] the window _sh
down so tightly that the movement of
Frame Curtain is restricted
3. Loose,ly assemble Me sill support
using the parts in Figure 3.
4. Se]_;t the, _s,iti,on that wil!l place the
sift support near the outer most po,int
on sill (_e Figure 4)
° Be careful when you [nstaff
the _binet (:Frame Guid_ willl
broken easily),.
5_
Attach the sift support to the cabinet
track holle in relatiion to the sel_ted
position using 2 Ty_ A screws in
each support(See Figure 4),
6 The cabinet should be [ns_lli_ wi#'l,a
ve_ slight tiff(about _!_"),downward
toward _e outside (S_ Figui_e,5)_
Adjust the _lt and the nut of sil!
support fo,r balancing t_hecabinet,,
7, Attach the cabinetto the window stool
by driving the screws ,(Type B:[,o,ength
sixteen millimeters and below.) through
the front angle into window stool
8, Puff ea_ Frame curtain fully to each
window sash track, and repeat step, 2.
Upper Guide
Window
Frame CuRa!n
Foam-Pc
Figure i
Figure 2
OUTDOOR
i
SillSuppom
Screw(Type A)
INDOOR
Screw(Type B}
#
Cabinet:
OUTDOOR Figure 4
Si_ Support
Scr_(Type IB)
S!HSuppeR:
Track
Figure 5
14 Room Air Conditioner