Minka Group K9614L-BNK User manual

Type
User manual

This manual is also suitable for

CAUTION: Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse box.
1. Remove the switch cup from the fan.
2. While holding the light kit assembly under your
fan, snap together the wire connection plugs .
3. Carefully push all wires back into the switch
cup, then install the light kit assembly onto the
mounting plate with 4 screws. Be sure to
tighten all screws. (Fig. 1)
4. Mount the glass shades
(Sold Separately) to the
light fixture by unscrewing partway the
thumbscrews on the glass holders, inserting
the glass, then gently tightening the
thumbscrews by hand evenly to the glass. DO
NOT OVER TIGHTEN. (Fig. 2)
5. Install 3 x 4W LED bulbs (provided). (Fig. 2)
Fig. 1
Fig. 2
CAUTION: To reduce The Risk Of Fire And
Electric Shock, This Light Kit Should Be Used
Only With The Fan Model F614. Manufactured By
Air Cool Industrial Co, Ltd.
Approximate maximum weight: 1.166 lbs
Manual design and all elements of manual design
are protected by U.S. Federal and/or State Law,
including Patent, Trademark and/or Copyright
laws.
Light kit
assembly
Screws
Molex
Glass shade
Light kit
assembly
Screws
4W Bulbs
ASSEMBLY INSTRUCTIONS
for Fan Light Kit,
Model# K9614L
BE SURE TO FOLLOW ALL STEPS IN THE ORDER GIVEN.
BE SURE POWER IS OFF AT FUSE, OR CIRCUIT BREAKER BOX.
READ AND SAVE THESE INSTRUCTIONS
  • Page 1 1

Minka Group K9614L-BNK User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI