GROUP:
DOCUMENT NUMBER:
REVISION:
Microphone Installation
A
1998-065-A-10-06
Telephone Entry
DOORKING
1. Remove microphone board.
2. Cut wire ties and remove wires.
3. Unscrew the wire terminals.
4. Screw new wire terminals to terminal strip.
5. Route wire harness through the wire shield.
NOTE: Do not screw the board down until the
microphone volume sensitivity has been adjusted.
6. Install and fasten microphone board.
Adjust Sensitivity
1. Use Phillips screwdriver to adjust the volume sensitivity.
2. Turn clockwise to increase the volume sensitivity.
3. Turn counter-clockwise to decrease the volume
sensitivity.
1998-065-A-10-06
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
DKS 1802 / 1802-EPD User manual
-
-
-
DKS 1812 Classic Owner's manual
-
-
-
-
-
-
