IDS IDS4000CF Installation guide

4” CARBON FIBER RESIDENTIAL OR COMMERCIAL

ENTRY DOOR STOP INSTRUCTIONS

Step One: Start on the top hinge. Loosen screws 2 and 4, remove screws 1 and 3 from

the wall side of hinge. Place belled end of IDS strap behind hinge. Pull down to lock into

place. Replace and re-tighten screws. Please see Note, if the strap does not seem to fit

properly.

Step Two: Loosen screws 1 and 4, remove screws 2 and 3 from the door side of hinge.

Place fingered end of IDS strap behind hinge. Keep strap tight, place 10 degrees shy of

desired stopping point. Replace and re-tighten screws. Repeat steps for bottom hinge.

Step Three: When satisfied with stopping point, push IDS strap inward while closing the

door. Leave door closed for a minimum of 15 minutes to set crease and memory. Trim

any excess strap from back of hinge with razor knife.

Note: If your IDS strap does not seem to fit properly behind the wall side of hinge, turn

the strap upside down and feed in behind hinge from below and pull up to lock into

place. This happens if your hinge is a Modified “S” Hinge, which is common on pre-hung

entry doors. Please contact us if you are experiencing any other difficulties.

***Only Fold Strap As Indicated***

Download PDF