SPT Buffers-989 User manual

Type
User manual

This manual is also suitable for

FEATURES
1. Suitable for all types of shoes, quickly and easily.
2. Dual buffers for a perfect polish.
3. One touch ā€“ easy control ON/OFF switch.
4. Comfortable design 31ā€ Stand-up Operation.
5. Input power ā€“ 120V/60Hz.
SAFETY INSTRUCTIONS
1. Do not use in damp or wet locations. Keep area dry.
2. Do not use in the presence of any flammable liquids or gases.
3. Keep away from children. When not in use, store in high and dry area, where
it is out of childrenā€™s reach.
4. Be cautious of loose clothing, which can be caught in moving parts.
5. Do not over-reach. Keep proper footing and balance at all times.
6. Disconnect power when not in use, before servicing and before changing
bonnets.
7. Limit each usage to a maximum of 3 minutes
WARNING
Before connecting the shoe polisher to a power source (receptacle, outlet, etc.),
be sure the voltage supplied is the same as specified on the polisher. A power
source with greater voltage will result in serious injury to the user, as well as
damage the polisher. Using a power source with lesser voltage will harm the
motor. If in doubt, do not plug in the polisher.
INSTALLATION
Important! Be sure unit is unplugged. Never change or install bonnet when power
is connected.
1. Install the Red Bonnet to the left side of the unit. Use wrench to hold shaft on
the right side and turn Red Bonnet counterclockwise.
2. Install the Black Bonnet to the right side of the unit. Hold Red Bonnet in place
and turn the Black Bonnet clockwise.
TO REMOVE BONNET
Refer to installation instructions.
1. Loosen the Black Bonnet by holding the Red Bonnet in place and turn
counterclockwise.
2. Use wrench to hold the shaft on the right side and loosen the Red Bonnet by
turning clockwise.
This appliance has a polarized plug (one blade is wider than the other). To
reduce the risk of electric shock, this plug is intended to fit into a polarized outlet
only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still
does not fit, contact Sunpentown, or a qualified electrician. Do not attempt to
modify the plug in any way.
  • Page 1 1

SPT Buffers-989 User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI