13
INSTRUCTIONS FOR USE
BEFORE USING THE APPLIANCE
PRECAUTIONS AND GENERAL ADVICE
USING THE HOB
COOKING TIPS
ENERGY SAVING TIPS
MAINTENANCE AND CLEANING
HOB ACCESSORIES
TROUBLESHOOTING GUIDE
AFTER-SALES SERVICE
INSTALLATION
41966023aGB.fm Page 13 Friday, February 25, 2005 5:11 PM
14
BEFORE USING THE APPLIANCE
•
Keep the packaging material (plastic bags,
polystyrene parts, etc.) out of the reach of
children, as they are potentially dangerous.
•
The packaging material is entirely recyclable, and
is marked with the recycling symbol .
•
Do not dispose of the various packaging materials
carelessly, but do so responsibly and in full
compliance with local authority regulations
governing waste disposal.
•
Make sure that the appliance is not damaged,
broken or scratched.
•
Ensure that the installation and electrical
connections are performed by a qualified
technician, following the manufacturer’s
instructions and in compliance with the
regulations of the local electricity supply
company.
•
Make sure that the hob is not damaged, broken,
cracked or scratched.
•
Ensure that the installation and electrical
connections are performed by a qualified
technician, following the manufacturer’s
instructions and in compliance with current local
safety regulations.
This appliance is marked according to the European
directive 2002/96/EC on Waste Electrical and
Electronic Equipment (WEEE).
By ensuring this product is disposed of correctly,
you will help prevent potential negative
consequences for the environment and human
health, which could otherwise be caused by
inappropriate waste handling of this product.
The symbol on the product, or on the
documents accompanying the product, indicates
that this appliance may not be treated as household
waste. Instead it shall be handed over to the
applicable collection point for the recycling of
electrical and electronic equipment.
Disposal must be carried out in accordance with
local environmental regulations for waste disposal.
For more detailed information about treatment,
recovery and recycling of this product, please
contact your local city office, your household waste
disposal service or the shop where you purchased
the product.
To get the best results from your hob,
please read these instructions carefully and
keep them to hand for future consultation.
41966023aGB.fm Page 14 Friday, February 25, 2005 5:11 PM
15
PRECAUTIONS AND GENERAL ADVICE
Attention: Danger of electrocution:
•
Before any maintenance on the appliance, disconnect it from
the electrical power supply by unplugging; this is to prevent
any risk of electrocution.
•
If the appliance is damaged, do not use it, but unplug it from
the mains and contact After-sales Service.
•
The glass ceramic hob has good mechanical resistance and is
designed to withstand minor accidents and incorrect usage;
however, if an object falls on it and damages the surface, do
not use the hob. Disconnect it from the electrical power
supply and call the nearest After- sales Service.
•
Do not use the hob as a work surface.
•
Do not use utensils, plastic containers or aluminium foil for
cooking directly on the glass ceramic hob.
•
Ensure the bottom of pots and pans are dry before using.
•
When the hob is in use, the surfaces of the hotplates become
very hot, so children must be kept safely away from the hob.
•
Fats and oil can easily catch fire if overheated, so never leave
pans unattended while frying, etc.
•
Do not leave the hotplates on without a pan in position.
•
Take steps to ensure electrical cables (e.g. of small household
appliances) do not come into contact with hot parts of the
hob.
•
Do not leave synthetic fabrics, plastic utensils or other
flammable objects on the hob.
•
Avoid scratching the surface of the hob with the bottom of
pots and pans.
•
To obtain the best cooking results, it is advisable to use flat-
bottomed stainless steel pots and pans.
The diameter of the bottom must be equal to that of the
hotplate or slightly greater.
•
Take steps to prevent sugar and other sugary ingredients such
as jam, jelly and juice, from coming into contact with the
hotplates. If you do have a spill, clean the hob thoroughly right
away, following the cleaning instructions.
•
If the hob is fitted with halogen lamps, do not stare at them.
41966023aGB.fm Page 15 Friday, February 25, 2005 5:11 PM
16
USING THE HOB
The hotplates are clearly marked on the hob.
The hotplates are switched on, adjusted and switched off again
by turning the knobs on the oven in a clockwise direction.
Next to the 4 knobs are numbers from 0 to 12 or 10.
Each number corresponds to a power output level for cooking.
The hob features 4 luminous residual heat indicators; these light
up to indicate that the temperature of
the hotplates is still high.
The residual heat indicators light up as soon as the hotplates
reach a temperature high enough to cause burns.
They remain lit even after the relative hotplate is turned off and
only switch off once the hotplate temperature is no longer
dangerous.
HOW TO USE THE KEEP-WARM PLATE
Cooking zone/keep-warm zone
The hob is marked out with 4 cooking zones and some models
also feature a keep-warm zone.
Each cooking zone has an adjustment switch on the electric
oven.
The lay-out and operation is described in the instructions manual
provided with the oven.
Sensor buttons for the keep-warm zone
The ON/OFF button is positioned on the front edge of the hob,
in front of the keep-warm zone.
To switch on the keep-warm zone:
- press button A, marked with the symbol check that LED
A1 is lit up
The red led of button will start flashing.
If no other button is touched for 10 seconds, the keep-warm
function is automatically disabled and switched OFF (led off). After
enabling the keep-warm zone with button , touch button
to switch on the keep-warm zone (red light remains on).
To switch off the keep-warm zone, touch button again.
Important:
It is very important to keep the controls area (sensor
buttons) dry, in order to prevent the keep-warm plate
from switching off.
The surface of the keep-warm zone reaches a
temperature of around 100 °C.
To install the glass ceramic hob with the keep-warm zone
on the left, make sure that installation is carried out to
the right, in combination with the oven.
To install the glass ceramic hob with the keep-warm zone
on the right, make sure that installation is carried out to
the left, in combination with the oven.
41966023aGB.fm Page 16 Friday, February 25, 2005 5:11 PM
17
COOKING TIPS
Position of knobs For the following preparations:
12 10 Bringing water to the boil
10-11 10 Frying food and cooking meat
9-10 9-10 Making potato fritters, roasting sirloin, steak, cordon bleu
8-9 8-9 Roasting meat, chops, steak, omelettes, hamburgers
7-8 7-8 Gently roasting sausages, liver, eggs, dumplings
5-6 6-7 Cooking large quantities of food, e.g. minestrone and soup
4-5 5-6 Steaming vegetables, making vegetable stews
3-4 4-5
Cooking meat, fish
2-3 3-4 Cooking rice/milk, foods made with meat and eggs
1-2 2-3 Heating ready meals
1 1 Making omelettes, delicate sauces, melting butter, chocolate, jelly
0 0 “Off” position
41966023aGB.fm Page 17 Friday, February 25, 2005 5:11 PM
18
ENERGY SAVING TIPS
MAINTENANCE AND CLEANING
HOB ACCESSORIES
•
Use pots and pans whose bottom diameter is equal to, or
slightly larger than, that of the cooking zones.
•
Only use flat-bottomed pots and pans.
•
If possible, keep pot lids on when cooking.
•
Cook vegetables, potatoes, etc. with little water in order to
cut down cooking time.
•
A pressure cooker allows you to save even more energy and
time.
Important: never clean the appliance with high pressure
water or steam cleaning equipment.
1.
Use a suitable cloth or kitchen paper to clean the hob.
2.
Do not use abrasive powders or detergents, oven cleaning
sprays, spot or rust removers, bleach, sponges with abrasive
surfaces, or iron pan scourers.
3.
Clean the hob if possible after every use, when it is still warm
or after it has cooled.
4.
Do not allow food residue to burn onto the hob.
5.
It is best to remove any food residue before it burns onto
the surface, using the scraper provided, or a razor blade.
6.
Should any sugar spill onto the hob, clean it up immediately,
otherwise it will melt on the hot surface of the hob.
Child guard accessory AMH 122
This accessory can be obtained from the After-Sales Service
under Part N° 4819 310 18436.
NO!
41966023aGB.fm Page 18 Friday, February 25, 2005 5:11 PM
19
TROUBLESHOOTING GUIDE
The hob does not work:
- Check for the presence of mains electrical
power.
- Switch the hob off and then back on again, to see
if the problem has been solved.
- Check that the knob is not turned to “0”. Set the
all-pole disconnect switch to “Off“ for several
minutes and then turn it back to “On“.
AFTER-SALES SERVICE
Before contacting After-Sales Service:
•
See if you can solve the problem yourself with the
help of the suggestions given in chapter
“Troubleshooting guide“.
If after the above checks the fault persists,
contact the nearest After-sales Service.
Please give:
•
a brief description of the fault;
•
the type and exact model of the hob;
•
the service number (i.e., the number that follows
the word SERVICE on the rating plate, located
under the hob) The service number is also
indicated on the warranty booklet;
•
your full address;
•
your telephone number and area code.
If any repairs are required, please contact an
authorised After-sales Service
(to guarantee
that original spare parts will be used and repairs
carried out correctly).
Failure to comply with these instructions may
compromise the safety and quality of the
product.
41966023aGB.fm Page 19 Friday, February 25, 2005 5:11 PM
20
INSTALLATION
Important information
This product has been designed, manufactured and
marketed according to the following:
- safety objectives of “Low Voltage” Directive 73/23/EEC;
- protection requirements of “EMC” Directive 89/336/EEC
amended by Directive 93/68/EEC.
The appliance has a type “Y” degree of protection against
fire;
it can therefore be placed against a wall higher than the
worktop.
DECLARATION OF CONFORMITY
The components of this appliance conform to EEC Directive
89/109; and can therefore come into contact with foodstuffs.
ELECTRICAL CONNECTION
To be done before connection to the electricity supply.
The appliance must be installed by a qualified electrician who is
fully aware of current safety and installation regulations.
Specifically, installation must be carried out in compliance with
the regulations of the local electricity supply company.
The
appliance must be connected to the electricity supply by
means of an all-pole disconnect switch with minimum
contact gap of 3 mm.
Make sure that the voltage indicated on
the rating plate corresponds to the voltage in your home.
Regulations require that the appliance is earthed: all conductors
(including the earth conductor) must be of the appropriate size.
The manufacturer declines all liability for injury to persons or
animals and for damage to property resulting from failure to
observe the above regulations.
INSTALLING THE HOB
1.
Fit the hob into the housing, as indicated by the
manufacturer
2.
Remove the drawer from the oven and push it into the
housing unit so that the earth wire and connectors of the
hob can be connected. For Oven-Hob connection, ensure
the colours of connectors match. Unscrew the nut of the
earth screw on the top cover of the oven and insert the
yellow/green earth wire, leaving the washer in place. Fully
tighten the nut back onto the screw.
3.
Push the oven into the housing unit so that it is flush with the
front and secure it at the sides using the 4 screws (supplied).
4.
Loosen the screws and remove the trim that secures the
terminal block at the bottom of the oven.
5.
Connect the power supply cable (min 1.0 m long) to the
mains, as shown in the oven diagram.
6.
Close the terminal block and trim again, screwing down
tightly.
7.
Reposition the drawer.
Dual Zone
Keep warming
Front Right
Rear Right
Rear Left
Front Left
Earth
41966023aGB.fm Page 20 Friday, February 25, 2005 5:11 PM
21
INSTALLATION
Assembly
To assemble the hob, use the supplied spring clips, brackets and
screws.
1.
Fit the clips into the corresponding holes under the hob as
shown in fig. 1/2.
2.
Position the brackets in the holes as shown in fig. 3, in
accordance with the thickness of the worktop.
3.
Secure the screws in the holes.
Fig. 3
41966023aGB.fm Page 21 Friday, February 25, 2005 5:11 PM
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Whirlpool AKT 320/IX Program Chart
-
Whirlpool G2P HID User guide
-
Whirlpool HB D50 S User guide
-
-
-
-
-
-
-
Other documents
-
Bauknecht ETPI 5620 IN User guide
-
-
Tricity Bendix SE211X User manual
-
Tricity Bendix SE 211 User manual
-
Creda 50cm User manual
-
Miele H 212 E User manual
-
-
-
-
Tricity Bendix SE210S User manual
