hand wheelstop motion screw
clamp washer drive belt cover
screw driver
big wheel
Allen screw
handle new drive belt cover
5/32" Allen key
1/8" Allen key
main belt
new belt
1
Unscrew and remove the stop motion
clamp stop screw.
2
By hand, unscrew & remove the Łstop
motion clamp screw.
3
Remove the clamp washer from under
the stop motion screw Store the stop
motion stop set screw, stop motion
screw, and the clamp washer.
4
Remove the drive belt cover held by
two screws.
5
Remove longer main belt. Turn hand
wheel to assist removal.
6
Remove the hand wheel. Wheel slides
off.
7
Put the big wheel on the end of the
shaft making sure that the teeth on the
wheel are facing the sewing head.
8
Install the new drive belt. Slip the belt
over the motor pulley and then slip
over the big wheel. At this point it
might be necessary to set the correct
belt tension. Loosen the motor bracket
screw - move the bracket downwards
will tighten the belt upwards will loosen
the belt – securely tighten the screw
after the setting the belt tension.
9
Slip the drive belt off from the big
wheel and remove the big wheel making
sure the drive belt stays on the motor
pulley. With the big wheel removed
install the drive belt cover that comes
with Cuda Crank kit.
10
Put the big wheel back onto the shaft
and slip the drive belt onto the big
wheel.
11
Turn the big wheel by hand until the
two holes to access the screws are
point ing upwards.
12
Slightly push the drive belt over and
away from you - this will allow you to
get the Allan Key in to securely tighten
the drive belt screws.
/
