Lighthouse L/H 3LEDPULL User manual

Brand
Lighthouse
Model
L/H 3LEDPULL
Type
User manual
FLASHLIGHT OPERATION
1. Push switch up on left hand side to light the 3 LEDs.
2. Push switch down to turn off the LEDs.
CHARGING YOUR TORCH - SOLAR OPERATION
Switch the power off. Face the solar panel towards
the light source to collect light and begin the charging
process.
Attention: This product is designed to be charged
under any indoor or outdoor environment where
there is a light source, however, for the best
charging status, exposure to sunlight is
recommended.
MECHANICAL OPERATION - CORD PULL
1. Switch the power off.
2. Grip the ring with your fingers and pull.
3. Stop pulling and release when the length of cord
comes to about 70 - 80cm.
4. Continue pulling the cord for 1- 2 mins.
5. Place the ring back in the product to complete
charging.
Attention: Avoid hard or sudden pulling while
charging. An interval of 5 mins is recommended
when the cord has been pulled over 200 times in
4 mins, this will prevent the product overheating.
ATTENTION!
1. Switch the power off when not in use.
2. Avoid shining the beam directly into peoples eyes.
3. Protect the solar panel from being struck by hard
objects or dropping on the ground.
4. Keep the solar panel clean for maximum effiency.
5. Always ensure the torch is switched off when not
in use or being recharged using the solar panel.
BATTERY REPLACEMENT
1. Twist the battery compartment cover
counterclockwise by using a coin to open.
2. Insert the battery into the compartment with the
negative side downwards/positive upwards.
3. Place the cover back and tighten up with a coin.
BATTERY TYPE
Rechargeable Lithium LR2450, 3.6v 110Ah
Solar or Cord Pull 3 LED Torch
L/H 3LEDPULL
  • Page 1 1

Lighthouse L/H 3LEDPULL User manual

Brand
Lighthouse
Model
L/H 3LEDPULL
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents