Page is loading ...
Quick Reference 931703C © 2023, CyberData Corporation, ALL RIGHTS RESERVED© 2023, CyberData Corporation, ALL RIGHTS RESERVED 931703C Quick Reference
Suggested Outdoor Installation for Security
Contacting CyberData
Network In
AC Power In
Drip Loop
Drip Loop
Inside Wall
011471
Overhang
Overhang
Weatherproof with
Silicone Sealant
011471
Optional Second Speaker
Primary Speaker
Weatherproof with
Silicone Sealant
See "Replacing the
Speaker Wire" Diagram
(Secure Side)
Outside Wall
at Least 10 Feet
Above Ground
or 3 Meter
Sales: 831-373-2601 ext. 334
Support: 831-373-2601 ext. 333
Support Website: https://support.cyberdata.net/
RMA Department Contact and Status: https://support.cyberdata.net/
Warranty Information: https://support.cyberdata.net/
Corporate Headquarters
CyberData Corporation
3 Justin Court
Monterey, CA 93940, USA
Phone: 831-373-2601
Fax: 831-373-4193
https://www.cyberdata.net/
Features
• Weather and corrosion resistant design
• IP66 rating
• 20 watts continuous duty
• Designed for good speech intelligibility
• Adjustable mounting base
• 3.28 foot (1 meter) connected cable
Dimensions
8.82 [224]
2 x
0.276 [7]
1.89 [48]
4.92 [125]
0.98 [25]
9.33 [237]
4.57 [162]
4.92 [125]
7.36 [187]
Open End Cable Length: 39.4 [1000]
Dimensions are in Inches [Millimeter]
The IP Endpoint Company
Installation Quick Reference
IP66 Analog Horn
011471
© 2023, CyberData Corporation, ALL RIGHTS RESERVED 931703C Quick Reference Quick Reference 931703C © 2023, CyberData Corporation, ALL RIGHTS RESERVED
Tool Required:
1) Size #2 Phillip Screwdriver
2) 11/16" or 17mm Open Wrench
Step 1:
Remove the Phillip Screws from Speaker End Cover
Remove the Cord Grip and the Flat O-Ring
Cut and Remove the Cable
Step 2:
Disconnect the Quick-Connects from the Terminals with a Pair of Pliers
Pull the Cable Out from the Speaker End Cover
3) A Needle Nose Pliers
Note #1
Cable Tie Here
Step 3:
Route the Cable Through the Cable Exit
Crimp the Quick-Connects with a Pair of Pliers,
Pull the Cable Lightly to Ensure Good Contact
Install the Cable Tie to Cable Jacket for Strain Relief
Approximately 3.5" [90mm]
Note:
1) Cable Jacket Diameter Range from
0.235" to 0.25" [6mm to 6.35mm]
Install Quick-Connects into Terminals
View from the Top of Magnet
Negative (-)
Positive (+)
Wire Color (Black)
Wire Color (White)
(Discard the Flat O-Ring)
Flat O-Ring
Cord Grip
Phillip Screw
Female
Cable Tie
Round O-Ring
Quick-Connect
Accessory Kit
*
*
Cord Grip
Round O-Ring
Replacing the Speaker Wires
/