Dell PowerEdge SC1425 User guide

www.dell.com | support.dell.com

Creating an Embedded SATA Controller RAID Array

To easily create a RAID array when using the system’s embedded SATA controller,

perform the following steps:

Turn on your system.

Press <F2> immediately after you see the following message:

<F2> = Setup

See "System Setup Program" in the

User’s Guide

for additional information.

Enable RAID in the

Integrated Devices

options in the System Setup program.

See your CERC SATA 2s documentation for information on configuring RAID drives.

The CERC SATA 2s RAID driver is available at

support.dell.com

____________________

Information in this document is subject to change without notice.

Reproduction in any manner whatsoever without the written permission of Dell Inc. is strictly forbidden.

Trademarks used in this text: Dell and the DELL logo are trademarks of Dell Inc.

Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names

or their products. Dell Inc. disclaims any proprietary interest in trademarks and trade names other than its own.

October 2004

Page is loading ...