A hose that attaches to a sink spray can burst
If It Is Installed on the same water line as
the dishwasher, If your sink has one, it is
recommended thai lhe hose be dbconnectsd
and the hole plugged.
If yourexistingfaucetadapter isnot compatiblewith
the "quickconnect=hoseassemblysupplied;
• Connectthe faucetadapter (Includedwfih
dishwasher)toyourInueeL
• If yourlaucetis inclusiveofa "male" type
(threaded) connecgan,use onlythe standard
rubberwasher (Smmthick)suppUed inside
adapter.Removethe second (Smmthick) rubber
washer,
• * • =
For bestoperalbg results,incoming waler pressure
shouldbe between 15 and 120 poundsper
square inch(psO,incoming water supplyforthe
dishwasherIs controlled bya "pressureswitch"
appllcaticn,so if householdwater pressureIslow.
dishwasherfilltk'newillbe Ianger.
FOR BEST RF.SULTS:
Yourdishwashercleans bysprayinga mixture of hot
cleanwaterand detergent(underpressure)against
thesoiledsurface ofdishes,The water is pumped
througha rotating spray arm, drainedthrougha Bier
removingfoodand so_d particlesand pumpedback
ftwoughthe sprayarm
Soiled waterIspumped out and replacedwithclean
water at the end ofasuh cycle.(the numberof times
dependson the cyclebeingused) Fur bestcleaning
results,the watertemperaturemust be at least
130=F(55°C}. Topreventdishwasherdamage, the
tempemlure ol theincomingwaist supplyshodid not
exceed 160"F (71"C).
[_'Jr_ j I,'_ ;'Rrk'T.-J_ZJ]
Youro3shwashercomesequippedwith e "quick
connect"(fib & drain)hose assembly,
A quickconnect faucetadepter must be lostalled on
the faucetbeforeyou can connectthe dishwasher.
This adaptermincluded insideyourdishwasher.
The quickconnectfaucet adapteris compatible with
faucets inclusiveof eithermale (exterior)and tern=de
• Ifyour laucet is induslvo ofa =female"type
(threaded) connection,bothrubberwashers(Srem)
must be Instalisdinsidethe tap adapter.
• The minimumheightclearancerequiredto install
yourdishwasherona countertopsurfacewith
overheadcupboardsIs 17-1/4" (43.8cm)
• Make sure them isan electricalsupply(outlet)
w_in distance ofthe alectrroal powersupplycord,
(6 feet1182.8 cm).
• Make surethe water supplyfaucetconneclionis
withindistanceofthe (fill& drain)hose assembly
(6 feet / 182.8em).
• The dishwasher must beinstalledon a "solid" level
surlaca,
• Tolevelthe dishwasher,adjustthe 4 levelscrews
(feet)under the dishwasher.
Usewith Inside
threaded faucet cdiy
Push ccl]a,rdown
and slipfaucet
_ connecter onto
the faucet
Bleederbulton _apter
nterfor)threadedfaucetconnections.
.Screwthe laucet adapter ontothe faucet.(check
forleaks, usa Teflontaps to allminals if
necessary)
• Connectthe open end of the drain hosetothe
drainportconnectionat the backol the
dishwashercabinetand securewithhoseclamp.
(Inct',_ed)
• Connectthe hot water inlst hosetothe water inlet
valveat the beck of thedishwashercabinet,(do
notover*lightento avoiddamage le threads)
• Attashthe quick-connaslontothe faucet adapter.
by pullingdown the (outer)lockingcollar ofthe
quickconnect, whilepushingIhe quickconnect
upwardupontothe laucat adapter,
• When the quink-conneclsnaps ontothe faucet
adepler, releaseths lockingcollar.Check fora
positivef'_L
• Slowly openthe hotwater lineandcheck for any
signofwater leaks at all hoseconcecticns.
If leaks are located, Immediately closethewater
supplyand repair the hoseconnections.