Astria Fireplaces Spectra Instruction Sheet

Brand: Astria Fireplaces

Model: Spectra

Type: Instruction Sheet

This manual is also suitable for

LSS3540

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE

P/N 750148M Rev. D 05/2015

HEARTH PRODUCTS

KITS AND ACCESSORIES

CERAMIC PANEL & LOG

PLACEMENT GUIDE

P750148M

CERAMIC PANEL & LOG PLACEMENT GUIDE FOR LSS-35 & LSS-40

SPECTRA SERIES GAS APPLIANCES

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE. 1

CERAMIC PANEL AND LOG

PLACEMENT GUIDE

CERAMIC PANEL & LOG PLACEMENT GUIDE FOR LSS-35 & LSS-40 SPECTRA SERIES GAS APPLIANCES

LSS-35 AND LSS-40

SPECTRA SERIES

750,148M

REV. C

05/2003

GENERAL INFORMATION

This ceramic panel and log and placement guide has been prepared to

present detailed placement illustrations and provide instruction to assist

in the initial (new appliance) setup and after the annual cleaning and

inspection cycles. The information provided here is to be used in

conjunction with the Homeowner's Care and Operation Instructions

provided together with this document in the appliance literature packet.

Please read the Homeowner's Care and Operation Instructions completely

before completing the procedures detailed in this placement guide.

INITIAL INSTALLATION CONSIDERATIONS

If the ceramic panels and logs are being installed for the first time,

the following paragraphs apply:

DO NOT attempt to install the logs until the appliance installation

has been completed, the gas line connected and tested for leaks

and the initial burner operation has been checked out.

Step 1. Remove the boxed ceramic panels on top of the appliance.

Handle panels carefully to prevent breakage.

Step 2. Remove the appliance front door.

Step 3. Cut and remove the nylon securing the log grate and the

boxed log set to the interior of the fireplace.

Step 4. Remove the logs from their packaging. Handle logs

carefully to prevent breakage.

Step 5. Remove the restraining strap from the grate tines.

Remove the grate from the interior of the fireplace.

CERAMIC PANEL, LOG AND GLOWING EMBER PLACEMENT

Step 1. Install the ceramic panels as shown in

Figure 3

. Panels

should be placed in the order shown.

A. Tilt and slide the top edge of the back panel toward the rear,

behind the baffle and pivot the bottom inward to position it

vertically as shown.

B. Align and slide the left and right bottom panels inward as

shown. Slide the front panel toward the back, until it touches the

left and right panels. Be sure there are no gaps between the panels.

C. Slide the left and right side panel inward with the orientation

of the marked "L" and "R" in their proper position as shown.

Step 2. Position the individual logs as shown in

Figures 4 and 5

Logs should be placed in the order shown.

Figure 1

Figure 2

Step 3. Separate the Glowing Ember (Rockwool) into pieces about

the size of a quarter

(

see

Figure 1)

. Keep the pieces fluffed up, not

matted. Distribute these pieces over the front burner and between

the log as shown in

Figure 2

. Do not use more than is necessary.

When properly positioned, the Glowing Embers will cover

approximately 85% of the front burner.

Note: This appliance is provided with enough Glowing Embers for

several applications, do not feel compelled to use all that is in a new

bag. For best glowing effect, replace the ember material annually .

Replacement Glowing Embers are available (Catalog Number 88L53).

Proper log and twig placement is critical to encourage outstanding

flame appearance and prevent sooting. When positioned properly

as shown, twigs will be positioned between flame peaks and will not

impinge any flames.

Refer to

page 3

for LSS-35 appliances and to

page 4

for LSS-40 appliances.

LENNOX HEARTH PRODUCTS

Glowing

Embers

(Rockwool)

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

CERAMIC PANEL PLACEMENT

Figure 3

Back Panel

Marked "L"

Catalog Number for the entire Ceramic Panel set: 41M8601 (for LSS-35) and 41M8701 (for LSS-40).

Baffle

Marked "R"

Side Panel

(Right)

Side Panel

(Left)

Bottom Panel

(Right)

Bottom Panel

(Left)

Bottom Panel (Front)

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

LSS-35 LOG PLACEMENT

Figure 4

Log

Number Description

1 Log, Front/Bottom/Center

2 Log, Rear

3 Log, Center

4 Log, Front/Left

5 Log, Front/Right

6 Log, Right

7 Log, Top/Right

Catalog Number for the entire

log set: 35M6101

Align holes on the bottom of log (1) over the

tabs and push down.

Align groove at the bottom of

log (4) over the tyne and slide it

backward to touch log (2).

Align groove at the

bottom of log (5)

over tyne and slide

forward.

Align holes at the bottom

of log (3) over the pins.

Align groove at the bottom

of log (2) over the grate and

push it toward the rear. Place log (6) between

90° bend and log (5).

Rest log (7) on lower

logs, over the flattened

surfaces of the logs.

P750148M

CERAMIC PANEL & LOG PLACEMENT GUIDE FOR LSS-35 & LSS-40

SPECTRA SERIES GAS APPLIANCES

P/N 750148M Rev. D 05/2015

1508 Elm Hill Pike, Suite 108

Nashville, TN 37210

IHP.US.COM

Innovative Hearth Products reserves the right to make changes at any time,

without notice, in design, materials, speciﬁcations, and prices, and also to

discontinue colors, styles, and products.

Consult your local distributor for ﬁreplace code information.

P750148M

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

P/N 750,148M REV. C 05/2003

Lennox reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products.

Consult your local distributor for fireplace code information.

LHP

1110 West Taft Avenue • Orange, CA 92865

LSS-40 LOG PLACEMENT

Figure 5

Log

Number Description

1 Log, Front/Bottom/Center

2 Log, Rear

3 Log, Center

4 Log, Front/Center

5 Log, Front/Left

6 Log, Right

7 Log, Front/Right

8 Log, Top/Right

9 Log, Top/Left

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

Align groove at the bottom of log (5) over

the tyne and slide it forward.

Catalog Number for the entire

log set: 35M6201

See Figure 4.

See

Figure 4

See Figure 4

Slide As Close As possible To The

90° Flange Of Baffle

See Figure 4

Astria Fireplaces Spectra Instruction Sheet

Brand: Astria Fireplaces

Model: Spectra

Type: Instruction Sheet

This manual is also suitable for

LSS3540

Download PDF

report

Astria Fireplaces Spectra Instruction Sheet

This manual is also suitable for

Astria Fireplaces Spectra Instruction Sheet

Related papers

Other documents