Lithonia Lighting Wet Location Industrial Installation guide

I have reviewed the provided instructions for the XWMLED Row Mount. This document outlines the sequential steps required to properly install the mount, from preparing the housing to connecting the wiring. I'm ready to answer your questions about any of the documented procedures.
What is the first step in installing the row mount?

What should be installed after drilling the knockout?

Where should the wire be fed?

Continuous Row Mount for XWMLED

1) Need to drill the KO by tool as the circle mark on

the housing

2) Install the other coupler and liquid tight fitting onto

the hole

3) Feed the wire under the driver to reach the power

supply wire

4) Connect the input of the roll mount fixture to the

suppler wire

DISCONTINUED