Installation guide for EZ-NICHES DIVIDER
Materials Needed:
- EZ-NICHES Divider
- Silicone or caulking
- Modified thin-set mortar
- Tile and grout
Installation Instructions:
1. Apply silicone or caulking on the back of the EZ-NICHES Divider.
2. Place the Divider into the EZ-NICHES at your desired height.
3. Press the Divider firmly against the EZ-NICHES installation system to ensure a tight fit.
4. Use modified thin-set mortar to adhere tile directly onto the Divider. Follow the manufacturer's
instructions for mixing and application of the mortar.
5. Once the tile is installed, the Divider will be secured in place and will prevent any movement or shifting.
6. Allow the mortar to dry and set completely before grouting the tile. Follow the manufacturer's
instructions for mixing and application of the grout.
Note: The EZ-NICHES Divider is presloped and cut to fit into the 14X22 size niche, making it easy to
install and tile directly over. Apply silicone or caulking to hold it in place, and once you tile over it, the tile
will keep it secure and prevent it from moving.
Alpinebay, Inc | 1668 EL Pinal Drive, Stockton CA 95205 | [email protected]
Office: 209-462-1818 Fax: 209-462-8888
/