2. Gill
  3. 19.5" TAKE-OFF BOARD SYSTEM

Gill 19.5" TAKE-OFF BOARD SYSTEM Operating instructions

  • Hello! I have reviewed the installation instructions for the Gill Take Off Board Tray 442 - 19.5". This document provides guidance on installing the tray on a recessed concrete pad using anchor bolts, ensuring proper width, and drain installation. I'm ready to answer your questions about the installation process and its specifications.
  • How many anchor bolts are required for installation?
    What should the tray width be to ensure a proper lid fit?
    Is it recommended to install a drain?
WARNING: Cancer and Reproductive Harm –
For more information go to www.p65warnings.ca.gov
F
Trubolt Wedge Anchor
INSTALLATION INSTRUCTIONS
1. Using a bit whose diameter equals the anchor
diameter, drill hole to any depth exceeding the
minimum embedment. Clean hole.
2. Assemble anchor with nut and washer so that
the top of the nut is flush with the top of the
anchor. Drive anchor through material to be
fastened so that nut and washer are flush with
surface material.
3. Expand anchor by tightening nut 3 to 5 turns, or
to the specific torque requirement (see selection
chart).
htt
p
://www.itwredhead.com/trubolt
_
installation
_
instr.as
p
/