Sioux Chief 800-A, 800-P Installation guide

Hello! I've reviewed the provided Installation Instructions for the Weld One floor drain. The document outlines the necessary steps for a proper install, including securing the drain, connecting the pipe, and preparing the concrete slab. I'm ready to answer any questions you have about installing this floor drain.
What size pipe should be used with Weld One?

How should the drain pipe be connected?

What is the purpose of the hub?

What material should be placed around the drain before pouring concrete?

1. Secure the Weld One floor drain in position during ground-rough using re-bar

or wood stakes. Top of stakes should be driven lower than strainer level.

2. Level of strainer should be set at intended level of finish floor.

3. Solvent weld 2” ABS or PVC DWV pipe into drain hub according to solvent

cement / pipe manufacturer’s instructions and connect to drainage system.

Note: The hub of the Weld One is designed to provide proper pitch of ¼"/ft. for

drain pipe when connected properly.

4. Pack gravel around drain and pipe and pour concrete slab according to

design plans and/or local code.

5. Finish concrete area around drain with gentle slope toward drain strainer.

concrete

slab

1-800-821-3944 www.siouxchief.com

WELD ONE INSTRUCTION SHEET - 09/11

Installation Instructions

Always be aware of, and follow local plumbing codes

Failure to follow these instructions could result in personal injury or property damage

rebar stake

anchor

gravel

2” PVC/ABS

drain pipe