Instructions:
1. Installing the Clamp
1. Press the button on the side of the
clamp and place the bottom end of
the microphone clip gooseneck
inside. Release the button.
3. Connecting the Microphone gooseneck holder
2. Turn knob clockwise to tighten
connection.
3. Place microphone into clip.
Note: compatible with most
directional microphones. Larger
condenser microphones will not fit.
3. Rotate tablet holder and position
goosenecks freely to reach desired
angle.
1. Press the button on the side of the
tablet holder to release sliding end.
Place tablet against the opposite
end, then slide the other side back to
firmly grip your tablet.
2. Use the larger Allen key to tighten the
gooseneck to holder connection,
adjusting ease of rotation.
4. Installing your Device and Adjusting the gooseneck holders:
Bigger
Allen Key
2. Connecting the Tablet Gooseneck Holder
1. Screw gooseneck to the metal connec-
tion on the clamp base.
2. Use the smaller Allen key to screw the meter screw
into the gooseneck, tightening the connection.
Smaller
Allen Key
Place rubber grip flat insert into the clamp groove. Rotate
tightening handle counter-clockwise to widen around
surface ledge. Rotate clockwise to tighten until secure.
On a Flat Surface
Take out the insert from the groove, clamp on the clamp to a
tube then screw the tighting rod to tighten it securely.
On a Tube
Microphone Clip and Tablet Holder
Gooseneck Clamp Stand
for 7-13 Inch Tablets
PAD-MTG
-
1
