WE Walker Edison B48AIEB Bench Operating instructions

Type
Operating instructions

This manual is also suitable for

P.1
Assembly Instructions
Item # : B48AIEB
Revised 16/07/2019(L)
Please visit our website for the most current instructions, assembly tips, report damage,
or request parts. www.walkeredison.com
®
Walker Edison
TM
Copyright
©
201
9, by Walker Edison Furniture Co., LLC. All rights reserved.
General Assembly Guidelines
I. Ensure that all parts and hardware are available before beginning assembly.
II. Follow each step carefully to ensure the proper assembly of this product.
III. Two people are recommended for ease in the assembly of this product.
IV. The main type of hardware used to assemble this product are: bolts and screws.
V. Power tools should not be used to assemble this product.
P.2
VI. Drill may be needed for securing product to wall.
Copyright
©
201
9, by Walker Edison Furniture Co., LLC. All rights reserved.
Parts List
P.3
Copyright
©
201
9, by Walker Edison Furniture Co., LLC. All rights reserved.
1
2
3
4
4
4
4
P.4
Hardware List
The hardware quantities listed above are required for proper assembly.
Some extra hardware may also have been included.
Ø1/4x12mm Bolt 12
pcs
A
Ø1/4x30mm Bolt 2
pcs
B
C
M4 Hex Key 1
pc
Copyright
©
201
9, by Walker Edison Furniture Co., LLC. All rights reserved.
P.5
Step 1
Copyright
©
201
9, by Walker Edison Furniture Co., LLC. All rights reserved.
1
2
A
A
A
A
B
B
C
Using bolts (A,B) secure part (2) into part (1) with hex key (C)as per diagram.
P.6
Step 2
Copyright
©
201
9, by Walker Edison Furniture Co., LLC. All rights reserved.
A
A
A
A
C
4
4
4
4
3
Using bolt (A) secure part (4) into part (3) with hex key (C)as per diagram.
Note Do not fully tighten all the bolts until you finish assembling all parts .Once assembled ,go back
to fully tighten all bolts .This will make the assembly easier .
Step 3
P.7
Copyright
©
201
9, by Walker Edison Furniture Co., LLC. All rights reserved.
A
A
A
A
C
2
4
4
4
4
Using bolt (A) secure part (4) into part (2) with hex key (C) as per diagram. Then fully tighten all
the bolts.
P.8
Step 4
Copyright
©
201
9, by Walker Edison Furniture Co., LLC. All rights reserved.
Position the assembled unit at the desired location .If necessary, adjust the floor levelers at the
bottom of the legs (4) to the level the unit .
P.9
Step 5
Copyright
©
201
9, by Walker Edison Furniture Co., LLC. All rights reserved.
Final Assembly
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9

WE Walker Edison B48AIEB Bench Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI