WE HD8264 Operating instructions

P.1

Assembly Instructions

Item # : B48AIEB

Revised 16/07/2019(L)

Please visit our website for the most current instructions, assembly tips, report damage,

or request parts. www.walkeredison.com

®

Walker Edison

TM

Copyright

©

201

General Assembly Guidelines

I. Ensure that all parts and hardware are available before beginning assembly.

II. Follow each step carefully to ensure the proper assembly of this product.

III. Two people are recommended for ease in the assembly of this product.

IV. The main type of hardware used to assemble this product are: bolts and screws.

V. Power tools should not be used to assemble this product.

P.2

VI. Drill may be needed for securing product to wall.

Copyright

©

201

Parts List

P.3

Copyright

©

201

1

2

3

4

P.4

Hardware List

The hardware quantities listed above are required for proper assembly.

Some extra hardware may also have been included.

Ø1/4x12mm Bolt 12

pcs

A

Ø1/4x30mm Bolt 2

pcs

B

C

M4 Hex Key 1

pc

Copyright

©

201

P.5

Step 1

Copyright

©

201

1

2

A

B

C

Using bolts (A,B) secure part (2) into part (1) with hex key (C)as per diagram.

P.6

Step 2

Copyright

©

201

A

C

4

3

Using bolt (A) secure part (4) into part (3) with hex key (C)as per diagram.

Note Do not fully tighten all the bolts until you finish assembling all parts .Once assembled ,go back

to fully tighten all bolts .This will make the assembly easier .

Step 3

P.7

Copyright

©

201

A

C

2

4

Using bolt (A) secure part (4) into part (2) with hex key (C) as per diagram. Then fully tighten all

the bolts.

P.8

Step 4

Copyright

©

201

Position the assembled unit at the desired location .If necessary, adjust the floor levelers at the

bottom of the legs (4) to the level the unit .

P.9

Step 5

Copyright

©

201

Final Assembly

WE HD8264 Operating instructions

This manual is also suitable for

WE HD8264 Operating instructions

Related papers

Other documents