Powerplus POWLI236 Owner's manual

Type
Owner's manual

Powerplus POWLI236 is a versatile and powerful LED floodlight designed for both indoor and outdoor use. With its 20W power, it provides bright illumination of up to 1800 lumens, making it ideal for job sites, gardens, studios, and workshops. It features three different brightness modes (100%, 50%, and 25%) and a warning mode with flashing lights. The floodlight is equipped with a long-lasting Li-ion battery that offers a working time of up to 6 hours on a single charge. It also has an AC/DC adapter charger for convenient charging.

Powerplus POWLI236 is a versatile and powerful LED floodlight designed for both indoor and outdoor use. With its 20W power, it provides bright illumination of up to 1800 lumens, making it ideal for job sites, gardens, studios, and workshops. It features three different brightness modes (100%, 50%, and 25%) and a warning mode with flashing lights. The floodlight is equipped with a long-lasting Li-ion battery that offers a working time of up to 6 hours on a single charge. It also has an AC/DC adapter charger for convenient charging.

POWLI236 EN
Copyright © 2018 VARO P a g e | 1 www.varo.com
RECHARGEABLE LED FLOODLIGHT 20W
POWLI236
1 DOMAIN OF USE
Outdoor or indoor usage such as jobsite, garden, studio and workshop.
WARNING! Read this manual and general safety instructions
carefully before using the appliance, for your own safety. Your power
tool should only be passed on together with these instructions.
2 DESCRIPTION (FIG. A)
1. Wing nut
2. H-shaped base
3. Wing screws
4. Carrying handle
5. Charger socket
6. ON/OFF switch
7. Selection mode knob
8. Charging light
3 SYMBOLS
In this manual and/or on the machine the following symbols are used:
Read the manual before using the machine
In accordance with essential applicable safety standards of
European directives
4 WARNING
The floodlight may not be attached against a mast (pole). Best installed onto a fence
or a wall, in a warehouse, shop or a similar place.
Replace the protection glass immediately if damaged.
5 ASSEMBLING THE FLOODLIGHT ONTO THE STAND
First unscrew the black wing-nut (1).
Put the lamp on the H-shaped base (2) in such a way so that the two slots align. Put
the wing screw through both slots and tighten the nut.
By loosening the wing screws (3) on both sides of the lamp you can put the lamp into
the desired angle.
Lock the lamp in place by tightening the wing screws.
Check the safety distance between the body and inflammable surface when wall or
corner mounted
POWLI236 EN
Copyright © 2018 VARO P a g e | 2 www.varo.com
6 CHARGING FLOODLIGHT
Open the protective cap and push the plug into the charger socket
Plug the adapter into a suitable outlet. Do not use an extension cord. The charging
light (8) will light up red to show the battery is charging.
When the battery of the floodlight is fully charged, the light will change from red to
green until the charger disconnect from the mains.
NOTE: Put the protective cap back into the charger socket to avoid
water entering.
7 USING THE FLOODLIGHT
7.1 Different modes
LED 100% brightness: Press the ON/OFF switch (6), the work light will turn on at full
brightness. Working time in this mode is up to 2.5 hours on a full charge.
LED 50% brightness: Press the selection mode knob (7), the work light will decrease
to 50%. Working time in this mode is up to 3,5 hours on a full charge.
LED 25% brightness: Press the selection mode knob (7), the work light will decrease
to 25%. Working time in this mode is up to 6 hours on a full charge.
LED WARNING MODE: Press the selection mode knob (7), the work light will start
flasing.
Press the ON/OFF switch one more time, the light will turn off.
8 TECHNICAL DATA
Type
POWLI236
Power
20W
Floodlight facade material
tempered glass
Waterproof protection grade
IP44
High power LED bulb
life-span
50.000 hours
Lumen
1800/900/450
Color temperature
6500K
Batteries
Type
Li-ion
AC / DC Adaptor Charger.
Charger voltage
AC 100V-240V~50Hz
Output:
9V DC 2 A
Charging time
3.5 h
Working time 25% brightness
6h
Working time 50% brightness
3,5h
Working time 100% brightness
2.5h
Net weight
0,97kg
Dimensions
20x18x32,5cm
POWLI236 EN
Copyright © 2018 VARO P a g e | 3 www.varo.com
9 ENVIRONMENT
Should your appliance need replacement after extended use, do not
discard it with the household rubbish but dispose of it in an environmentally
safe way.
Waste produced by electrical machine items should not be handled like
normal household rubbish. Please recycle where recycle facilities exist.
Check with your Local Authority or retailer for recycling advice.
This product contains Li-ion. To preserve natural resources, please recycle or dispose of
batteries properly. Local, state or federal laws may prohibit disposal of Li-ion batteries in
ordinary trash. Consult you local waste authority for information regarding available
recycling and/or disposal options.
  • Page 1 1
  • Page 2 2
  • Page 3 3

Powerplus POWLI236 Owner's manual

Type
Owner's manual

Powerplus POWLI236 is a versatile and powerful LED floodlight designed for both indoor and outdoor use. With its 20W power, it provides bright illumination of up to 1800 lumens, making it ideal for job sites, gardens, studios, and workshops. It features three different brightness modes (100%, 50%, and 25%) and a warning mode with flashing lights. The floodlight is equipped with a long-lasting Li-ion battery that offers a working time of up to 6 hours on a single charge. It also has an AC/DC adapter charger for convenient charging.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI