POWLI236 EN
Copyright © 2018 VARO P a g e | 2 www.varo.com
6 CHARGING FLOODLIGHT
▪ Open the protective cap and push the plug into the charger socket
▪ Plug the adapter into a suitable outlet. Do not use an extension cord. The charging
light (8) will light up red to show the battery is charging.
▪ When the battery of the floodlight is fully charged, the light will change from red to
green until the charger disconnect from the mains.
NOTE: Put the protective cap back into the charger socket to avoid
water entering.
7 USING THE FLOODLIGHT
7.1 Different modes
▪ LED 100% brightness: Press the ON/OFF switch (6), the work light will turn on at full
brightness. Working time in this mode is up to 2.5 hours on a full charge.
▪ LED 50% brightness: Press the selection mode knob (7), the work light will decrease
to 50%. Working time in this mode is up to 3,5 hours on a full charge.
▪ LED 25% brightness: Press the selection mode knob (7), the work light will decrease
to 25%. Working time in this mode is up to 6 hours on a full charge.
▪ LED WARNING MODE: Press the selection mode knob (7), the work light will start
flasing.
▪ Press the ON/OFF switch one more time, the light will turn off.
8 TECHNICAL DATA