OWNER’S MANUAL
© 2005 MILLER Electric Mfg. Co.
OM-6620 224 609A
April 2005
Running Gear No. 50HD (300 026)
1. Parts List
WARNING
ELECTRIC SHOCK can kill.
• Do not touch live electrical parts.
• Turn Off power source and input disconnect device.
• Disconnect input plug or power conductors from
deenergized supply BEFORE moving power
source.
FALLING EQUIPMENT can cause injury
and damage.
• Properly install and secure power source into holes
provided on cart.
• Always secure or remove any tools stored on cart
before moving unit.
• Cart is only designed to handle weight of power
source, cables, torch, and a few simple tools − do not
overload cart with any additional weight.
Ref. 804 166-A
Tools Needed:
Description (Qty)
Item
No.
1 224 124 Pan/Shelf Assembly (1)
2 224 120 Bracket, Cable Hanger (4)
3 602 154 Screw, 250-20x.50 (4)
4 121 614 Retaining Ring (2)
5 602 250 Washer, .812 ID flat (2)
6 163 463 Wheel, 10 in (2)
7 224 114 Axle (1)
8 123 557 Caster, 5 in (2)
9 602 247 Washer, .531 ID flat (2)
10 602 216 Washer, .502 ID lock (2)
11 124 115 Nut, 438-14 Hex (2)
12 152 461 Nut, 250-20 Hex (4)
13 224 115 Handle (1)
14 601 941 Screw, 250-20x1.75 Hex (4)
224 388 Mounting Bracket (4)
see Section 3.
Be sure to provide Model when ordering
replacement parts.
Go to Section 2 for procedures to install cable
hangers and handle.
3/8, 7/16 in
3/8, 7/16 in
1
2
3
4
5
6
7
8
9
10
11
12
13
14
OM-6620 Page 2
2. Assembly Instructions
Ref. 804 166-A
2
1 224 120 Cable Hanger (2)
2 224 115 Handle
Install left and right cable hanger by
inserting a socket wrench through
access hole and securing hanger
using supplied hardware.
Insert handle into holes located
below top tray, and secure using
supplied hardware.
1
3. Installing Power Source
804 167-A
1
1 Mounting Bracket (224 388)
2 Screw, 250-20 x 1.00
(108 941)
3 Nut, 250-20 (152 461)
Place power source on top or bot-
tom tray. Select a set of holes that
align with the lower sheet metal
screws on unit.
Remove lower sheet metal screws
from unit. Install mounting brackets
and secure with supplied hardware.
Place unit between brackets and
reinstall sheet metal screws
through brackets and back into unit.
2
3
-
1
-
2
Miller RUNNING GEAR NO 50HD (300 026) Owner's manual
- Type
- Owner's manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Miller MC050242L Owner's manual
-
-
Miller Electric and SS-75D16 User manual
-
-
-
-
-
-
-