VTech VM343 Quick start guide

Category
Baby video monitors
Type
Quick start guide
Quick start guide
(Canada version)
VM343
VM305
Go to www.vtechcanada.com
for the latest VTech product
news.
Specifications are subject to change without notice.
© 2015 VTech Technologies Canada Ltd.
All rights reserved. 04/15. VM343_CA_QSG _V1.0
Document order number: 96-010503-010-100
Sound activation
When the infrared LEDs are on, the
image is in black and white. This is
normal due to external light sources.
Depending on the surroundings
and other interfering factors, like
lightings, objects, colors and
backgrounds, the display resolution
may vary. Adjust the baby unit’s
angle, or place the baby unit at a
higher level to prevent glare and
blurry display.
TIP
The baby unit has infrared LEDs that
allow you to see your baby at night or
in a dark room. When the baby unit
detects low light levels, the infrared
LEDs turn on automatically.
NOTE
Mount the baby monitor - Method 2
Insert the screws into the holes
and tighten the screws until
only 1/4 inch of the screws are
exposed.
Place the baby unit on the wall mount.
Tighten the screw into the threaded
socket at the bottom to secure the baby
unit. Align the holes on the wall mount
with the screws on the wall, and slide the
wall mount down until it locks into place.
NOTE
VOL
ON/OFF
3
1
2
SOUND-ACTIVAT ED SCREEN
On
O
Night vision
If you drill the holes into a stud, go to
step 3.
-OR-
Check for reception strength and
camera angle before drilling the
holes.
Place the wall mount on a wall and
then use a pencil to mark the top
and the bottom holes as shown.
Remove the wall mount and drill
two holes in the wall (7/32” drill bit).
If you drill the holes into an object other
than a stud, insert the wall anchors into
the holes. Tap gently on the ends with a
hammer until the wall anchors are flush
with the wall.
VOL
ON/OFF
Mount the baby monitor - Method 1
If you drill the holes into a stud, go to
step 3.
-OR-
If you drill the holes into an object other
than a stud, insert the wall anchors into
the holes. Tap gently on the ends with a
hammer until the wall anchors are flush
with the wall.
Align the wall mount and screws
with the holes in the wall as shown.
Tighten the screw in the middle
hole first, so that the wall mount
position is fixed. You can tighten
the other screw in the top hole.
Place the baby unit on the wall mount.
Tighten the screw into the threaded
socket at the bottom to secure the
baby unit.
Check for reception strength and
camera angle before drilling the
holes.
NOTE
Connect and power on
Place the baby monitor
At least 1 meter
(3 feet)
At least 1 meter (3 feet)
3
1
1 1
3
3
1
2
2
2
2
What’s in the box
Install the battery
1 set for VM305/VM3431 set for VM343
1
2
Place the wall mount on a wall and
then use a pencil to mark the top and
the bottom holes as shown.
Remove the wall mount and drill two
holes in the wall (7/32” drill bit).
  • Page 1 1
  • Page 2 2

VTech VM343 Quick start guide

Category
Baby video monitors
Type
Quick start guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI