KitchenAid KCBCR 20600 Program Chart

KCBCR 20600
KitchenAid
Brand
KitchenAid
Model
KCBCR 20600
Category
Fridge-freezers
Type
Program Chart

This manual is also suitable for

Product sheet
3
Quick Guide
Carefully read the user handbook provided before using the appliance.
Refrigerator Compartment
A. Fan and antibacterial and antiodour filter
(depending on the model)
B. Lamp or LED light (depending on the model)
C. Shelves
D. LED lights (depending on the model)
E. Crisper drawer cover
F. Crisper(s)
G. Rating plate (located at side of crisper)
H. Control panel
N. Dairy compartment
O. Door trays
P. Bottle holder (if provided)
Q. Bottle bin
Least cold zone
Intermediate zone
Coldest zone
Fruit and vegetable zone
Freezer Compartment
I. Top drawer (freezing area)
L. Middle and bottom drawers (storage area for
frozen and deep frozen food)
M. Ice cube tray (if provided)
Note: All shelves, door trays and racks are
removable.
The ideal temperatures for preserving foods are
already factory-set.
The characteristics, technical data and images
may vary according to the model.
4
Control panel
On/Standby
Press for 3 seconds to switch off the appliance. In
Standby mode, the two hyphens and the light in the
refrigerator compartment come on. To switch the
product back on, simply press the button briefly
again.
Note: This operation does not disconnect the
appliance from the power supply.
Refrigerator compartment temperature
A different temperature can be set using the
"Fridge" button.
Freezer compartment temperature
A different temperature can be set using the
"Freezer" button.
Temperature display
The display can alternately show the refrigerator
compartment temperature (between 2°C and 8°C)
or the freezer compartment temperature (between
-16°C and -24°C).
Fast Freeze
Press the "Freezer" button for 3 seconds 24 hours
before placing large amounts of food in the freezer
compartment. When the function is activated, the
icon lights up. This function is automatically
deactivated after 48 hours, or manually by pressing
the "Freezer" button again.
Note: The food to be frozen must not be touching
already frozen food.
Deactivating acoustic alarms
(Stop Alarm)
To deactivate the acoustic signals, press the "Stop
Alarm" button briefly.
Key Lock
The key lock can be activated/deactivated by
keeping the "key lock" button pressed for 3
seconds, until a confirmation sound is heard (the
icon lights up).
If you press any button while the key lock is active,
you will hear a sound and the "Key Lock" icon will
start to flash.
Opt Tariff function
The Opt Tariff function enables appliance energy
consumption to be concentrated in the reduced
rate hours (generally at night), when electricity is
readily available and is cheaper than during the
daytime (only in countries that utilise a time based
multi-rate system - check energy rates with the
local electricity company). To activate the function,
press the Opt Tariff button at the time the reduced
rate begins (depending on your specific tariff plan).
For example, if the reduced rate begins at 8 pm,
press the button at that time. When the Opt Tariff
LED is on, the function is active. Once the function
is activated, the appliance automatically adapts
energy consumption according to the time
selected, i.e. consuming less energy during the day
than at night.
IMPORTANT: To operate properly, the function
must be on during the night and day. The function
remains on until deactivated (or it is deactivated in
case of a power failure or appliance switch-off). To
deactivate the function, press the button again.
When the Opt Tariff LED is off, the function is not
active.
Note: The declared appliance energy consumption
refers to operation with the Opt Tariff function
deactivated.
Fan
The fan is preset as ACTIVE. The fan can be
deactivated by pressing the button
on the base (as shown in the
figure). If the room temperature
exceeds 27°C or if there are water
droplets on the glass shelves, the
fan must be on in order to ensure the correct
preservation of food. Deactivation of the fan
enables energy consumption to be optimised.
Sensor Fresh Control function
This function is used to quickly reach optimum
preservation conditions regarding temperature and
humidity inside the appliance. The fan must also be
on for it to work properly.
5
What to do if... Possible causes Cures
The control panel is
switched off, the
appliance does not
work.
The appliance could be in On/Standby
mode.
There may be an appliance power supply
problem.
Activate the appliance with the
On/Standby button
Make sure:
- there is not a power outage
- the plug is properly inserted in the
power socket and the mains double-
pole switch (if present) is in the correct
position (i.e. allows the appliance to be
powered)
- the household electrical system
protection devices are efficient
- the power cable is not broken.
The inside light
does not work.
The light may need replacing. Models with lamp: disconnect the
appliance from the power supply, check
the lamp and, if necessary, replace it with
a new one (see the section "Lamp or
LED replacement").
Models with LED lights: contact the
authorised Service Centre.
The appliance could be in
On/Standby mode
Activate the appliance with the
On/Standby button
The temperature
inside the
compartments is
not low enough.
There could be various causes (see
"Cures")
Make sure:
- the doors close properly
- the appliance is not installed near a heat
source
- the set temperature is adequate
- the circulation of air through the vents
at the bottom of the appliance is not
obstructed
There is water on
the bottom of the
refrigerator
compartment.
The defrost water drain is blocked. Clean the defrost water drain hole (see
the section "Appliance Maintenance and
Cleaning")
6
What to do if... Possible causes Cures
The front edge of
the appliance, at
the door striker
seal, is hot.
This is not a defect.
It prevents condensation from forming.
No cure is necessary.
The red light
flashes and an
acoustic signal
sounds
Door open alarm
It is activated when a door remains open
for a long period of time.
Close the doors of the product
to deactivate the acoustic signal. If the
acoustic signal does not go off, it is a
power failure alarm (see the section
Power failure alarm).
The red light
flashes and an
acoustic signal
sounds and remains
on even with the
door closed.
Power failure alarm
It is activated in case of a prolonged
power outage causing an increase in the
freezer compartment temperature.
Note: A different product temperature
cannot be set until the power failure
alarm is deactivated.
Before deactivating the acoustic signal, it
is advisable to pay attention to the
temperature shown on the temperature
display, corresponding to the highest
temperature reached in the freezer
compartment during the power failure.
Press the "Stop Alarm" button briefly to
deactivate the acoustic signal. After
pressing the button, the temperature
display shows the set temperatures again.
If the freezer compartment has not yet
reached the optimum food preservation
temperature, the freezer compartment
temperature alarm could be activated
(see freezer compartment temperature
alarm). Check the food before
consuming it.
The red light
comes on (without
flashing), an
acoustic signal
sounds and the
freezer
compartment
temperature
display flashes.
Freezer compartment temperature
alarm
The freezer compartment temperature
alarm indicates that the compartment
temperature is not optimum. This may
happen: with first use, after defrosting
and/or cleaning, if large amounts of food
are placed inside the freezer or when the
freezer door has not been closed
properly.
Press the "Stop Alarm" button briefly to
deactivate the acoustic signal. The red
light goes off automatically when
optimum temperature conditions are
reached. If the freezer compartment
temperature alarm stays on, contact the
Authorised Service Centre.
The red light
comes on, an
acoustic signal
sounds and the
letter "F" flashes on
the display.
Malfunction alarm
The alarm indicates a fault in a technical
component.
Call the authorised Service Centre. Press
the "Stop Alarm" button briefly to
deactivate the acoustic signal
400010780184
Printed in Italy
n
03/15
GB
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

KitchenAid KCBCR 20600 Program Chart

KCBCR 20600
KitchenAid
Brand
KitchenAid
Model
KCBCR 20600
Category
Fridge-freezers
Type
Program Chart
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents