BIQU B1 SE User manual

 .......................................

...............................

Ⅰ...........

 ..........................

 ...........................

 .............................

 ............................

     ...............

 ..................................

Ⅱ..............................

 .............................

.....

 ..............................

Ⅲ ................................

..........................

 ..........................

 .............................

..............................

Ⅳ ..............................

Fixe data cable and glass plate





Clean the nozzle with tweezers before automatic leveling

Set parameters of the printer

Add a new printer device in the slicing software

Import the file of printing model

Parameter settings of printing

After parameter settings , click "slice"

Fully insert filament to the heat break,The nozzle is

heated to 180~200°C to extrude Ensure that the extru-

sion is normal.The installation is complete.

Ⅳ 