Eurolux PR172 Owner's manual

Type
Owner's manual
Project Lights
PR172 Excluding: 2 x G5 maximum 35W T5 Fluorescent Tubes
PR173 Excluding: 2 x G5 maximum 35W T5 Fluorescent Tubes
ILLUSTRATIONS
PR172W / PR173W
PRODUCT CODE
Please read instructions before commencing installation and retain for
future reference.
ENVIRONMENTAL PROTECTION
Waste electrical & Electronic equipment regulations requires that any of our products showing this
marking must not be disposed of with other household or commercial waste. To prevent possible
harm to the environment or human health from uncontrolled waste disposal, please separate any
such products from other waste types and recycle it responsibly at your local facilities.
Cape Town - 9 Racecourse Road, Milnerton, 7441
Johannesburg - 10 Milkyway Avenue, Linbro Business Park, Sandton, 2065
email: [email protected], web: www.eurolux.co.za
L
N
1. Open the lid and x the lampholder
2. Connect the power
1. Install the tting into the ceiling
2. Put the lid back
if the lid with wind,the installation is the
same, just with 2pcs button to x the lid.
Install the tube.
OFF
ON
•Fitting:Pressed Steel
•Lamptype:
PR172 Excluding: 2 x G13 maximum 18W T8 Fluorescent Tubes
PR173 Excluding: 2 x G13 maximum 36W T8 Fluorescent Tubes
•Voltage: 220V - 240V ~ 50Hz
•Protectionagainstelectricshock: Class 1. Require earthing connection
•IPRating: 20. Dust Protected. Protected against solid foreign objects of 1.0mm Ø and greater
Protected against splashing water.
•MaximumAmbienttemperaturerange: 20ºC - 40ºC
•Commercial/domesticuse
•Notsuitableforoutdooruse
•Notforuseinareasexposedtomoisture
•Dimensions:
PR172: (L) 1180mm x (W) 45mm (D) 29mm
PR173: (L) 1480mm x (W) 45mm (D) 29mm
•AdditionalInformation:
Including Electronic Ballast; Power Factor: 0.95
PR172/PR173-attachments:
Iftheexternalexiblecableorcordofthisluminaireisdamaged,itshouldbeexclusivelyreplaced
bythemanufacturerorhisserviceagentorasimilarqualiedpersoninordertoavoidahazard.To
ensure that you get maximum longevity and maximum use out of your luminaire, please observe
the following safety instructions.
Electrical products can cause death, injury, or damage to property. Installation of the luminaire
mustbecarriedoutbyaqualiedelectrician,inaccordancewithSANS10142.Oncompletion
ofinstallation,ensurethattheCerticateofComplianceisupdated.
•Beforeconnectingthisluminaire,ensurethatvoltageindicatedontheratinglabelcorresponds
with the mains voltage in your home.
•Whenchangingthelamp,ensurethatthepoweristurnedoff.
•Thisluminaireischeckedinfullforconformitytothequalitystandardsandsafetyrequirements.
•Themanufacturer/supplierisnotresponsibleforanydamageofpropertiesandpersons,
caused by the incorrect use or installation of the luminaire.
•Shouldyoubeunsureofhowtoinstallthisluminairecorrectly,pleaseconsultaprofessional
electrician or your supplier for assistance.
•Ensureallitems/components,threadsandscrewsaretightlysecured.
IMPORTANT:
•Tamperingwiththisluminaire,IE.Usingsiliconsealersorincorrectcabling,willinvalidate
your warranty.
•Whentheprotectionglassisdamaged,itshouldbereplacedimmediately.Theluminairemust
not be used without the protection glass.
•Pleasecheckwhethertheconnectionofthepowercordissafeandreliablebeforeinstallation.
SPECIFICATIONS
IMPORTANT SAFEGUARDS
INSTALLATION
CLEANING
•Beforecleaningalwaysensurethepowersupplyisturnedoff.
•Donotimmersetheluminaireinwater.
•Noabrasiveproducts,solvents,detergentmaybeusedtocleanthisluminaire.
•Ensurethatthettingdoesnotcomeincontactwithcorrosivechemicals,etc.
•Coastalareasensurethattheluminaireiscleanedfortnightly.
Installation:
Switch the power off before commencing with the installation.
•Whendrillingisrequireforxingtheluminairetotherequiredsurfacepleaseensurethatno
pipes or cables are within the drilling area.
•Connectthewiresasshowningure
•Iftheheatsleeveissuppliedwithyourluminaire,pleaseconnecttheincominglive,Neutraland
Earth supply wires.
•Connecttheearth(green/yellow)supplywiringtotheearthterminal
•Connectthelive(brown/Red)Supplywiringtotheconnectorblockmarked
•Ensureallitems/components,threadsandscrewsaretightlysecured
•Ensurethelampsareseatedcorrectly.locateandtwist.
•Mounttheuppercoverandxitinplacewiththescrews.
Changingthelamp:
Switch the power off before commencing with the installation.
1. Always ensure the lamp has been allowed to cool before attempting to change the lamp.
2. Open the luminaire cover.
3. Carefully unscrew the lamp.
4. Carefully screw in the new replacement lamp.
5. Close the luminaire, fastening any loose screws before re-connecting the electricity and
turning the luminaire on.
•Alwaysensurethatthemainssupplyvoltageiscorrect.
•Alwaysreplacethelampwithoneofanidenticalrating.
•Ensurethatyoudonotplacetheluminairenearanycombustiblematerialsand/orsurfaces.
•Chokinghazard:Maycontainsmallparts.Keepawayfromchildren.
•Donotinsertyourngersoranypartofyourbodyintotheelectricalcontactandsocketsofthis
product whilst it is connected to the electricity supply.
•Itemmayvaryslightlyfromthepictureonthecarton.
  • Page 1 1
  • Page 2 2

Eurolux PR172 Owner's manual

Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI