OWNER’S MANUAL

MANUALLY TUNED SYNTHESIZER STEREO RADIO

WITH COMPACT DISC PLAYER

Installation.................................................................................................................. 3

Remove the Unit From the Dash Board................................................................... 4

Operation.................................................................................................................... 5

Radio Operation......................................................................................................... 6

PULL-OUT UNIT

1. Choose the mounting location where the

unit will not interfere with the normal

driving functions of the driver.

2. Avoid installing the unit where it would

be subject to high temperature, such as

from direct sunlight, or from hot air, from

the heater, or where it would be subject

to dust, dirt or excessive vibration.

METAL MOUNTING STRAP

HEX BOLT

FOR NON PULL-OUT VERSION

FOR PULL-OUT VERSION

1. Remove the metal strap attached to the back of the unit.

2. Disconnect all the wires of the unit and the antenna plug.

3. Lift up the handle and pull the trim plate out.

OPERATION

Rotate the button (4) to left or right to obtain the desired sound quality.

The dial pointer (5) indicates the frequency of current reception.

Press MODE button (6) to choose radio or CD mode.

During CD mode, the LCD (17) can show the current CD work state of the unit.

Press BND button (8) to change bands as below:

Rotate the TUNING knob (9) clockwise or anti-clockwise to adjust the frequency

upward or downward.

Gently insert a compact disc with the label side facing up into the disc slot (14).

the track.

Press (EJECT) button (13) to stop CD play and eject CD from slot. Receiver

switches to radio operation.

During CD playing, press button (12) to temporarily stop playing.

Press it again to resume playback.

or the previous track. Track numbers show on display.

During CD playing, press INTRO button (11) to play first several seconds of each

track. Press it again to stop introduction mode and listen to track.

During CD playing, press and hold RND button (7) for several seconds to play all

WIRING CONNECTION

SPECIFICATION

Channel Separation : More than 50 dB

Frequency Response : 100 Hz - 15 KHz

Frequency Range : 88 MHz – 108 MHz 88 MHz – 108 MHz

Intermediate Frequency : 10.7 MHz 10.7 MHz

Usable Sensitivity (Mono) : Better than 25 dBu Better than 25 dBu

Stereo Separation at 1 KHz : More than 24 dB More than 24 dB

Frequency Range : 520 KHz – 1620 KHz 530 KHz – 1710 KHz