TERK Technologies 143P005 User manual

Brand: TERK Technologies

Model: 143P005

Category: Network antennas

Type: User manual

This manual is also suitable for

SRB-MM

Limited Warranty

TERK

Technologies Corp. (TERK) warrants this product against defects in

terials or workmanship for one (1) year from the date of purchase.

During this war

ranty period, this product will be replaced without charge.

This war

ranty does not cover any damage due to acts of nature, commercial

use, a

ccident, misuse, abuse or negligence. This warranty is only valid in

the USA. Repla

cement as provided under this warranty is the exclusive remedy

of the

consumer. TERK shall not be liable for any incidental or consequential

damages

for breach of any express or implied warranty on this product,

except to the extent that limitations of this sort are prohibited by applicable law.

THERE ARE NO IMPLIED

WARRANTIES OF MERCHANTABILITY OR FITNESS

FOR A PARTICULAR PURCHASE EXCEPT TO THE EXTENT THAT IMPLIED

WARRANTIES OF EITHER SORT ARE REQUIRED BY APPLICABLE LAW, AND

IN SUCH

CASE, EACH WARRANTY IS LIMITED IN DURATION TO ONE YEAR.

Installing the Antenna::

Take your SIR-Mini (for SIRIUS Satellite Radio)

or XMicro (for XM Satellite Radio) and place the

antenna on the top of the bracket between the metal

tab and the cable pass-through hole (Fig.5).

Route the cable from the antenna through the top

of the bracket using the cable pass-through hole.

Determine the best route for the cable to reach the

satellite radio receiver.

Note: The cable has a very small diameter and should

be routed with care. Three feet of cable protector has

been included. Please install the cable protector around

the cable when going through areas that may cause

damage to the cable such as a door jamb or window. (Fig.4)

Once the cable has been routed to the satellite radio

receiver, plug the antenna connector into it.

Please refer to your satellite radio receiver owner’s

manual to activate your satellite radio service and

complete your receiver installation.

While holding the brackets together, install the lock

washers and the wing nuts (Fig.3). Before completely

tightening the wing nuts make sure that the ground

plane of the bracket where the antenna will be located

is parallel to the ground. Tighten both wing nuts so that

the bracket is secure.

Mounting the Bracket::

Select the top bar of either the driver’s side or

passenger side mirror mount (Fig.1). Place the

bracket on the front side of the bar (Fig.2).

Insert the two metal tabs of the small bracket

into the two slits near the top of the L-bracket

(Fig.2).

Lower the small bracket over the mirror bar until

the bolts in the L-bracket come through the

slots of the small bracket (Fig.2).

TRUCK MIRROR MOUNT BRACKET

Satellite Radio

SRB-MM

Works with Magnetic Mount Satellite Radio Antennas

Shown below with the TERK XMicro & SIR-Mini

Fig.2

Fig.5

Fig.4

Fig.3

L-Bracket

Small B

racket

Fig.1

For more information, visit www.terk.com,

For technical support, call 1.800.942.TERK (8375)

Made in China

One year limited warranty

The SIRIUS name is a trademark of

SIRIUS Satellite Radio

The XM name is a trademark of

XM Satellite Radio

TERK and TERK Technologies are trademarks of

TERK Technologies Corp. Commack, NY

Installation instructions printed on the inside of this card::

143P005

XMicro SIR-Mini

Cable Protector

XMicro SIR-Mini

TERK Technologies 143P005 User manual

Brand: TERK Technologies

Model: 143P005

Category: Network antennas

Type: User manual

This manual is also suitable for

SRB-MM

Download PDF

report

TERK Technologies 143P005 User manual

This manual is also suitable for

TERK Technologies 143P005 User manual

Related papers

Other documents