Power Saver
Power Saver
In addition to the newest four battery modes (Performance, Normal, Power saving and Super
saving), you can also customize your settings to fulfill various needs.
Please select your preferred battery mode in [Settings] -> [Power management] -> [Power
Saver].
Note: This function may not be available in some models, countries or firmware versions.
Check default settings of battery modes
You can check estimated remaining standby time (it will change according to battery level) and
default settings of different modes. Except for "Customized" mode, settings of all modes cannot
be adjusted.
Customize your battery settings
You can also select "Customized" mode to manually change settings of CPU performance,
brightness, network and extend standby.
Smart switch - Auto switch to another mode when battery is low or in a scheduled time
1. Switch by battery level:
Make your device auto switch to Super saving mode when battery is low.
2. Switch by schedule:
Make your device switch to another mode during a period of time set by your preference.
SIM Cards
Triple slots: Dual SIM & one MicroSD card
Slot 1: 3G/4G Nano SIM card
Slot 2: 3G/4G Nano SIM card
Both SIM card slots support 3G WCDMA / 4G LTE network band. But only one SIM card can
connect to 3G WCDMA / 4G LTE service at a time.
Slot 3: Supports up to 2TB MicroSD card
How does a customer set up APN information
on our Android phones?
How does a customer set up APN information on our Android phones?
Customer(s) can go to APPS- SETTINGS – MORE – (MOBILE) or (CELLULAR)
NETWORKS –
ACCESS POINT NAMES – Then tap on the upper right (+) sign to add an APN in the field(s).
Most cellular providers will provide the APN information on their website or when the customer
contacts them.
Putting in the correct APN (Access Point Name) information will provide the customer with
4G/LTE data speeds from the carrier they are on.
Instructions with screenshots below.
1. Tap on APPS.
2. Tap on Settings.
3. Tap on More.
4. Tap on Cellular Networks.
5. Tap on Access Point Names. Make sure the (Data enabled) check mark box is ticked and the
(Preferred network type) box shows 2G/3G/4G.
6. Tap on the (+) icon to manually add an APN (Access Point Name).
7. You will be taken to the (Edit access point) menu. Tap on any field (not set) to manually edit it
with the carrier's APN information.
8. Tapping (Name) field will bring up the on screen keyboard to input the Name field for the
carrier. Example below.
9. After verifying that all the APN information is filled in correctly from the carrier, tap on the
OPTIONS icon (represented by 3 dots on the upper right of the screen) to SAVE or DISCARD
the changes.
10. SAVE or DISCARD options drop down menu. Tap to execute SAVE or DISCARD changes.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
