Belkin AV4 User manual

Belkin
Brand
Belkin
Model
AV4
Type
User manual

This manual is also suitable for

1 2 43
Connect transmitter to video source
and to power. Connect IR emitter
cable. Turn on video source.
Route IR emitter cable
end to the front of your
video source.
Using the included IR emitter, ScreenCast can
relay signals from your remote control to your
video source. You will aim this in step 3.
Connect receiver to TV
and to power. Make sure
receiver’s top surface is
visible in order to receive
signals from your remotes.
Use the source’s remote at
close range to find where
IR signals are received.
Then aim the end of the
IR emitter at that spot.
turn
HDMI
IR
HDMI
SCREENCAST AV 4
SCREENCAST AV 4
TV INPUT: HDMI
INPUT
OK
OK
5 6
Use your TV remote to set the input
to the HDMI port that the ScreenCast
receiver is connected to.
Remove the battery tab from the
ScreenCast remote and use it to
complete the on-screen setup.
Optional wall-mounting of receiver: Use the included
wall-mounting template and hardware to mount the
receiver to the wall. Make sure that at least the front half
of the top surface is visible, so that it can receive signals
from your remotes.
© 2011 Belkin International, Inc. All rights reserved. All trade names
are registered trademarks of respective manufacturers listed.
F7D4515 • 8820-00862 Rev. A03
  • Page 1 1
  • Page 2 2

Belkin AV4 User manual

Belkin
Brand
Belkin
Model
AV4
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents