Whirlpool 1109 User manual

Brand: Whirlpool

Model: 1109

Category: Washing machines

Type: User manual

This manual is also suitable for

301
5019

5019 301 01109

Programme

Care

Labels

Max.

Load

Type of wash / Notes

- respect the manufacturer's recommendations on the care label

Detergents and Additives Special options Max

Spin

Speed

rpm

Pre-

wash

Main

Wash

Softener Start

delay

Eco Pre-

wash

Easy

ironing

Intensive

rinse

Rinse

hold

Variable

spin

Cotton/ Antibacterial

95 °C

40-60-95 °C

5.0

Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made

of cotton and linen.

Selecting “Cotton 95°, this programme eliminates bacteria, ensuring sanitization of your

laundry. The bacterial removal efficiency has been tested following a similar methodology to

the NF EN 13697 standard of Nov. 2001



Yes

       

Max.

Cotton

40 - 60 °C

Jeans

40 °C

5.0

Normally soiled cotton jeanswear and garments made of jeanslike material such as

trousers and jackets.



Yes

   

– –

 

Max.

Synthetics

30 - 40 - 60 °C

30-40-60 °C

2.5

Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira),

polyamide (Perlon, Nylon) or blends with cotton.



Yes

       

1000

Delicates

30 - 40 °C

1.5 Curtains and delicate clothing, dresses, skirts, shirts and blouses.



Yes

 

–



– –

 

1000

Daily load

40 °C

3.0 Slightly to normally soiled textiles made of cotton and/or synthetics. – Yes

 

– –

   

Max.

Quick wash

30 °C

3.0 Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton. – Yes

 

– – – –

 

Max.

Wool

Cold - 40 °C

- 40 °C

1.0

Only woollens labelled with the woolmark and identified as machine washable.

This programme (40°) is tested and approved by The Woolmark Company for machine

washable wool.

– Yes

 

– – – –

 

1000

Handwash

40 °C

1.0

Textiles made of linen, silk, wool and viscose marked as “handwashable”.

This programme (40°) is tested and approved by The Woolmark Company for hand-washable

wool.

– Yes

 

– – – –

 

400

Lingerie

30 °C

1.0

This programme is particurarly suitable to treat delicate lingerie (use of laundry net

strongly recommended).

– Yes

 

– – – –

 

400

Rinse & Spin – 5.0 Same as the last rinse and the final spin in the “Cotton” programme. – –

 

– – –

  

Max.

Spin – 5.0 In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. – – –



– – – – –



Max.

Drain – – Drain only - no spinning. Alternative method of terminating programme after “Rinse hold”. – – –



– – – – – – –

A. “Door open” indication

This washing machine is equipped with

automatic safety functions which detect

and diagnose faults at an early stage

and react appropriately, e.g.:

B. “Service” indication

C. “Water tap closed” indication

D. “Clean pump” indication

Whirlpool is a registered trademark of Whirlpool USA.

E. Programme selector

F. “Start/Pause” button

G. Spin speed selector

H. Programme sequence indicator

I. “Reset” button

J. “Start delay” button

K. Time display

 : option / Yes : dosing required

For improved garment care spin speed is restricted in these programmes.

PROGRAMME CHART

The wool and handwash cycles of this machnes have been tested and approved by The Woolmark Company for the

washing of Woolmark garments labeled as “machine wash” or “hand wash” provided that the garments are washed

according to the instructions on the garment label and those issued in this programme chart.

M0512

5019 301 01109

Programme

Temperature

(°C)

Load

(kg)

Water

(l)

Energy

(kWh)

Approx. Programme

Duration

(hours : minutes)*

Cotton / Antibacterial 95 5.0 49** 1.90 2:00

Cotton 60 5.0 44 0.95 2:10

Cotton with “Eco”*** 60 5.0 44 0.85 2:20

Cotton 40 5.0 44 0.60 2:00

Jeans 40 5.0 60 0.60 2:10

Synthetics 60 2.5 50** 0.70 1:30

Synthetics 40 2.5 45 0.55 1:15

Delicates 30 1.5 50 0.50 0:45

Daily load 40 3.0 45 0.45 1:00

Quick wash 30 3.0 40 0.40 0:30

Wool

40 1.0 55 0.60 0:45

Handwash 40 1.0 45 0.60 0:40

Lingerie 30 1.0 45 0.50 0:36

CONSUMPTION DATA

Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the

home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type

of wash.

* The remaining time indicator can deviate from the values in the table, because it takes into account the household conditions

applicable at that time.

To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.

*** Reference Programme for Energy Label.

ADD DETERGENTS, CLOSE THE DOOR AND

SELECT THE PROGRAMME

SELECT ANY DESIRED OPTION

“DOOR OPEN” INDICATION

Before starting and after end of a programme, the

lamp lights to show the the door can be opened.

As long as a wash programme is running, the door

remains locked and must on no account be forced

open. In case you have an urgent need to open it

during a running programme, refer to “Cancel (Reset)

a running programme before the end”.

RED INDICATIONS

“Service”

Lighting up of the “Service” indication can be caused

by a fault in an electrical component. Refer to the

“Troubleshooting Guide” in your “Instructions for

Use”; if the fault persists, contact our After Sales

Service.

“Water tap closed”

The appliance has no or insufficient water supply.

Open the water tap: if the indications still lights

up, refer to the “Troubleshooting Guide” in the

Instructions for Use.

“Clean pump”

Waste water is not pumped out. Check whether the

drain hose is kinked or the filter must be cleaned:

in the latter case refer to the Instructions for Use

(“Removing the Filter”).

Push the button(s) of any option(s) desired - the

respective indication lamp lights up.

When the combination of programme and additional

option(s) is not possible, the indication lights switch

off automatically. Unsuitable combinations of options

are deselected automatically.

“Eco” button

• With modified temperature profile and a slightly

prologned washing duration, the optimum

combination of excellent washing result and even

lower energy consumption is achieved.

“Prewash”

button

• Only for heavily soiled loads (for example sand,

granular dirt) sensible. Increases the cycle time by

approximately 15 min.

Whirlpool is a registered trademark of Whirlpool USA.

PROGRAMME START

Open the tap and press the “Start/Pause” button.

The indication lamp next to the “Start/Pause”

button lights up. The programme sequence indicator

shows the current programme phase, running from

left to right through Wash, Rinse, Spin/Drain.

The time display shows the remaining programme

time. Due to variations in load and temperature of

inlet water, the remaining time is newly calculated

in certain programme phases. If this is the case, an

animation appears on the time display.

PROGRAMME END

• All the lights of the programme sequence indicator

are off, and the “Door open” indication lights up.

1. Turn the programme selector to the “Off/O”

position.

2. Close the water tap.

3. Open the door and unload the machine.

4. Leave the door ajar to allow the drum to dry.

CHANGE PROGRAMME AND/OR OPTIONS

AFTER PROGRAMME START

1. Press the “Start/Pause” button to pause the

programme. The light blinks.

2. Select the new programme (with temperature),

any options and another spin speed if you want.

3. Press the “Start/Pause” button again. The new

programme continues at the same position where

the previous programme was interrupted. Do not

add detergent for this programme.

CANCEL (RESET) A RUNNING PROGRAMME

BEFORE THE END

• Do not use liquid detergent for the main wash

when activating the “Prewash” option.

“Easy ironing” button

• Can be used together with “Cotton”, “Synthetics”

and “Daily load” programmes to make ironing

easier.

• Increases the water quantity and the clothes are

spun very gently.

“Intensive rinse” button

• More water is added and rinse cycle is prolonged.

• This option is particularly suitable for areas with

very soft water, washing baby linen and helps

people with allergies.

“Rinse hold” button

• The laundry remains in the last rinse water

without pregressing to the final spin cycle to avoid

creasing and prevent colours from changing.

• This option is particularly recommended for the

programmes “Synthetics”, “Daily load” and

“Delicates”.

• It is particularly useful if you want to postpone

spinning to a later time, or if you want to drain

only.

• If you select “Rinse hold” do not leave items to

soak for too long.

Note: The programme stops to “Rinse hold” at

the time the “Rinse hold” lights in the programme

sequence indication is on. The indication lamp

next to the “Start/Pause” button blinks.

START DELAY

Add detergents as indicated on the front page and as

described in the chapter “Detergent and Additives” in

your Instructions for Use.

1. Turn the programme selector to the desired

programme and temperature.

2. The time display shows the duration of the

chosen programme (in hours and minutes), and

the “Start/Pause” indication lamp is blinking.

3. The indication lamp of the predefined spin speed

lights up.

Terminate the “Rinse hold” option:

• Press the “Start/Pause” button; the programme

will terminate automatically with the final spin

cycle for the present wash programme.

• If you do not wish to spin the clothes, turn the

programme selector knob to the “Drain”

programme and press the “Start/Pause” button.

“Variable spin”

button

• Every programme has a predefined spin speed.

• Press the button to set another spin speed.

• If spin speed “0” is selected, the final spinning is

cancelled but intermediate spin peaks remain

during rinse. The water is drained out only.

The “Reset” button cancels a programme before

the end.

• Press the “Reset” button for at least 3 seconds.

Any existing water is drained out before the door

can be opened.

The “Start delay” allows to run the machine at the

consumer’s convenience, for example at night when

electricity is cheaper.

Do not use liquid detergent

when activating “Start delay” option.

• Select programme, temperature and options.

• Press the “Start delay” button to select the delay

time by 1 to 23 hours.

• Press the “Start/Pause” button.

The countdown of the delay time begins; the

“Start delay” indication lamp and the dot on the

display will keep blinking until the programme

starts.

• The time delay indication disappears when the

programme starts and it is replaced by the

remaining programme time.

• Once having pressed the “Start/Pause” button,

the number of hours preselected can be reduced

by pressing again the “Start delay” button.

To cancel the “Start delay”

...before you press the “Start/Pause” button:

• Turn the programme selector to another position

or press the “Reset” button.

...after having pressed the “Start/Pause” button:

• Press the “Reset” button for at least 3 seconds

- the start delay time disappears from the time

display.

Whirlpool 1109 User manual

Brand: Whirlpool

Model: 1109

Category: Washing machines

Type: User manual

This manual is also suitable for

301
5019

Download PDF

report

Whirlpool 1109 User manual

This manual is also suitable for

Whirlpool 1109 User manual

Related papers

Other documents