Pyle PLDVD130 User manual

Brand: Pyle

Model: PLDVD130

Category: CD players

Type: User manual

OWNER’S MANUAL

Mobile Video System

• Multi-subtitle Languages Function

• Multi-audio Languages Function

• Multi-angle Function

• Parental Control

PLDVD130

FEATURES

Compatible with PAL DVD (Video

CD) and NTSC DVD (Video CD)

This player can play discs recorded in

either PAL or NTSC format.

• A single LSI chip now integrates all

major DVD playback circuit functions

including MPEG2 decoder, video D/A

converter, and audio decoders.

• L/R stereo analog audio outputs for

connection to existing head unit aux

inputs. Video output is composite

video.

• Supplied remote handles

multi-function software (multi-language

audio-track/subtitle, multi-angle, multi-

story, etc.), plus all basic functions.

USE THIS PRODUCT SAFELY

When Driving

Keep the volume level low enough to be

aware of road and traffic conditions.

When Car Washing

Do not expose the product to water or

excessive moisture. This could cause

electrical shorts, fire or other damage.

When Parked

Parking in direct sunlight can produce

very high temperatures inside your

vehicle. Give the interior a chance to

cool down before starting playback.

Use the Proper Power Supply

This product is designed to operate with

a 12 volt DC, negative ground battery

system (the regular system in a North

American car).

Protect the Disc Mechanism

Avoid inserting any foreign objects into

the slot of this player.

Failure to observe this may cause

malfunction due to the precise

mechanism of this unit.

Use Authorized Service Centres

Do not attempt to disassemble or adjust

this precision product. Please refer to

the Service Centre list included with this

product for service assistance.

For Installation

The unit should be installed in a

horizontal position with the front end up

at a convenient angle, but not more than

30°.

Safety Information ........................................................................................4

Disc Notes .....................................................................................................5

Installation .....................................................................................................6

Electric Connection ......................................................................................7

Remote Control.............................................................................................8

Preparing the Remote Control................................................................................9

Loading a DVD/VCD/CD Disc.................................................................................9

Ejecting a Disc ........................................................................................................9

Location and Function of Keys...............................................................................9

Basic Operation ..........................................................................................10

On-Screen Display Function.................................................................................11

Multi-audio Language Function............................................................................12

Menu Function (For DVD only)..............................................................................13

Title Menu Function (For DVD only) ......................................................................13

Multi-subtitle Language Function (For DVD only).................................................13

Multi-angle Function (For DVD only).....................................................................13

MP3 Disc Play.......................................................................................................13

Setup ............................................................................................................14

Initial Setup ...........................................................................................................14

General Setup.......................................................................................................14

Speaker Setup ......................................................................................................16

Audio Setup ..........................................................................................................16

Preferences Setup ................................................................................................17

Defaults Table .......................................................................................................19

Specifications..............................................................................................20

CONTENTS

CAUTION:

MOBILE DVD PLAYER IS A CLASS I

LASER PRODUCT. HOWEVER THIS

MOBILE DVD PLAYER USES A

VISIBLE/INVISIBLE LASER BEAM

WHICH COULD CAUSE HAZARDOUS

RADIATION EXPOSURE IF DIRECTED.

BE SURE TO OPERATE THE MOBILE

DVD PLAYER CORRECTLY AS

INSTRUCTED.

USE OF CONTROLS OR

ADJUSTMENTS OR PERFORMANCE OF

PROCEDURES OTHER THAN THOSE

SPECIFIED HEREIN MAY RESULT IN

HAZARDOUS RADIATION EXPOSURE.

DO NOT OPEN COVERS AND - DO NOT

REPAIR YOURSELF. REFER SERVICING

TO QUALIFIED PERSONNEL.

WARNING:

• TO REDUCE THE RISK OF FIRE OR

ELECTRIC SHOCK, DO NOT EXPOSE

THIS EQUIPMENT TO RAIN OR

MOISTURE.

• TO REDUCE THE RISK OF FIRE OR

ELECTRIC SHOCK, AND ANNOYING

INTERFERENCE, USE ONLY THE

RECOMMENDED ACCESSORIES.

• THIS DEVICE IS INTENDED FOR

CONTINUOUS OPERATION.

This product incorporates copyright

protection technology that is protected

by method claims of certain U.S. patents

and other intellectual property rights

owned by Macrovision Corporation and

other rights owners. Use of this

authorized by Macrovision Corporation,

and is intended for home and other

limited viewing uses only unless

otherwise authorized by Macrovision

Corporation. Reverse engineering or

disassembly is prohibited.

SAFETY INFORMATION

Region Management Information

Region Management Information:

This Mobile DVD Player is designed and

manufactured to respond to the Region

Management Information that is recorded

on a DVD disc. If the Region number

described on the DVD disc does not

correspond to the Region number of this

Mobile DVD Player, this Mobile DVD

Player cannot play this disc.

DISC NOTES

Disc formats supported by this player

DVD

12 cm disc

(Single-sided disc only)

Video CD

12 cm disc

MP3

12 cm disc

Discs which cannot be played with this

player

• DVD-ROM

• DVD-R/DVD-RAM

• CDV

• CD-G

Handling and Cleaning

• Dirt, dust, scratches and warping disc

will cause misoperation.

• Do not place stickers or make

scratches on discs.

• Do not warp discs.

• A disc should always be kept in its

case when not in use to prevent from

damaging.

• Do not place discs in the following

places:

1. Direct sunlight

2. Dirty, dusty and damp areas

3. Near car heaters

4. On the seats or dashboard

Disc Cleaning

Use a dry soft cloth to wipe the surface.

If the disc is quite dirty, use a soft cloth

slightly moistured with isopropyl (rubbing)

alcohol. Never use solvents such as

benzine, thinner or conventional record

cleaners as they may mar the surface of

the disc.

Note:

A disc may become somewhat scratched

(although not enough to make it

unusable) depending on your handle it

and conditions in the usage environment.

Note these scratches are not an

indication of any problem with the player.

Preparing New Discs with Rough

Spots

A new disc may have rough edges on its

inside and outside edges. If a disc with

rough edges is used, the proper setting

will not be performed and the player will

not play the disc. Therefore, remove the

rough edges in advance by using a ball

point pen or pencil as shown on the right.

To remove the rough edges, press the

side of the pen or pencil against the

inside and outside edges of the disc.

Rough spots

on inside edge

Ball point pen

or pencil

Rough spots on

outside edge

Label side up

Do not touch

the underside

of the disc

Do not bend

Wipe the disc from center

toward the outside edge

SCREW

M4x5

INSTALLATION

Note:

1. First remove the two screws that locket the unit core, then attach the brackets on

both sides of unit with screws (M4x5), last install the unit with screws (M5x25).

2. When fix the unit, you can slide the screw (M5x25) to left side or right side to meet

your needed position. In the figure above, select two holes among the positions

that marked 1, 2, 3 and 4 to fix the bracket.

SCREW

M4x5

SCREW

M5x25

SCREWS LOCKED THE UNIT CORE

ELECTRIC CONNECTION

(OPTIONAL)

DIGITAL AUDIO

DVD PLAYER

AC/DC

ADAPTOR

CIGARETTE LIGHTER

REMOTE CONTROL RECEIVER

(OPTIONAL)

DC 12V IN DC 12V OUT

REMOTE

DIGITAL

AUDIO

A/V OUT

L/R VIDEO

VIDEO OUT

AUDIO R OUT

AUDIO L OUT

WHITE

RED

YELLOW

REMOTE CONTROL

1. POWER Press POWER to turn the unit ON or OFF

2. 0 - 9 Numeric buttons

3. GOTO Disc search button, cooperatively used with numeric buttons

4. Press it to stop playback

5. / Press to start forward rapidly & to reverse rapidly

6. / Press to skip to the next track & press to skip back one track

In case of MENU mode, those buttons served as cursor buttons

7. SUBTITLE Changing of the SUBTITLE language on multi-subtitle language

DVD disc

8. SETUP Display the SETUP menu

9. TITLE Display the TITLE menu that is stored in DVD disc

10. DISPLAY Display statistical disc information during playback

11. REPEAT Switch the Repeat mode of DVD/VCD/CD disc

12. Press once to pause a play, press again to resume continuous

playback

13. SLOW Changing for slow forward/reverse playback motion

14. ENTER Confirm the Track/Chapter selected with the number key or

selected with the cursor buttons on TV screen

15. AUDIO Changing of the AUDIO soundtrack on multi-audio soundtrack

DVD disc. Changing of the sound mode of the VCD/CD disc

16. ANGLE Changing of the view angle on multi-angle DVD disc

17. MENU Display the root menu that is stored on the DVD disc

Changing between PBC ON and PBC OFF on the VCD disc

6 5

REMOTE CONTROL

Preparing the Remote Control

Inserting the Batteries

1. Open the battery compartment cover.

2. Insert the new batteries. Make sure

that the positive and negative

terminals of the batteries are oriented

indicated.

3. Close the cover

Battery: Two AAA size battery.

Using the Remote Control

Face the remote control towards the

player front face IR mark (remote control

signal reciver).

Operation angle: About ± 30 degree in

each the direction of the front of the IR

mark.

To prevent damage to the unit, be sure

to follow the connection diagram

(page 7).

Loading a DVD/VCD/CD Disc

1. Turn the ignition on the the accessory

position.

2. Press the

button (1) on the front

panel or

(POWER) on the remote

control.

3. Insert the disc with printed side facing

up into the disc slot (2).

4. The player starts playback

automatically.

Ejecting a Disc

Press button (3) to eject the disc.

2. Disc Slot

8. IR

1 2 73 4 58 6

Location and Function Of Keys

BASIC OPERATION

Stopping Play

- Brief press the

(Stop) button to stop

the unit playback, when press the

button on the front panel or button

on the remote control, it can

continuous

normal playback.

- Press

(Stop) button twice, it will stop

the playback and go back to initial

Track/Chapter.

Rapid Forward/Rapid Reverse

Press

FF & REW during play.

Each time the button is pressed, the

speed of rapid forward/reverse changes

according to the disc as follow.

DVD:

VCD/CD:

MP3:

Skipping Track

Press SKIP

/ on the remote handset

/ buttons on the front panel

during playback. Press

or to skip

to next track, and

or to back one

track. Note: For some VCD 2.0 dics

(PBC-playback control),

/ and /

buttons may be unavailable.

Slow Motion Play

Press SLOW button during playback.

Each time the button is pressed, the slow

mode changes according to the disc as follow.

DVD:

VCD:

Note: For VCD, in any slow mode, press

ENTER button to return to normal playback.

Normal Playback 2X 4X 6X 8X

Normal Playback 1X 2X 3X 4X

Pause (still picture)

Pressing the

button on the front

panel or

button on the remote control

during playback will stop play temporary.

Return to normal playback, press the

button on the front panel or

button on the remote control once again.

Repeat

Press the REPEAT button to select repeat

mode as follow.

DVD:

Press the REPEAT button to select repeat

mode as follow.

VCD/CD:

Press the REPEAT button to select repeat

mode as follow.

Continuously repeat at the current chapter/

track, when selected REP-ONE mode.

2. Select REP-ALL mode to continuously

repeat all chapter/track on the current

disc.

3. When the player finish playback the

current discc last chapter/track, it will

stop display the elapsed time. When

selected REPEAT OFF mode (REP-

ONE & REP-ALL disappear at the

screen display).

4. REPEAT feature does not support

VCD2.0 (with PBC ON).

Normal Playback SF 2X SF 4X SF 8X

SR 8X SR 4X SR 2X

CHAPTER REPEAT ON TITLE REPEAT ON

REPEAT OFF

REP-ONE REP-ALL REPEAT OFF

Normal Playback SF 1X SF 2X

Step BWD SF 3X

Normal Playback 2X

Press ENTER Button

Disc Search (GOTO)

FOR DVD

Press GOTO button twice, the screen will

display the following message:

You can select the item you want to

watch through TIME setting by using

numeric buttons and ENTER key.

FOR VCD (WITH PBC OFF)/CD:

Press GOTO button once, the screen will

display the following message:

Use numeric buttons to input the time

directly.

Remote Sensor (IR)

Point the remote handset to the remote sensor.

Receive the signal from remote handset.

Turning the player on/off

Press the button on front of panel or

press

(POWER) button on

remote

control to turn the player on or off.

TITLE 01/01 TIME -- : -- : --

00:00:25

GOTO -- : --

00:00:25

BASIC OPERATION

On-Screen Display Function

Press the DISPLAY button during

playback to display the contents of the

current disc on the screen.

Example:

DVD:

(1) Press DISPLAY for the first time:

Title Number, Total Title Number, Chapter

Number, Total Chapter Number of this

Title of the disc currently being played

will be shown on the screen, along with

the elapsed time.

(2) Press DISPLAY for the second time:

(3) Press DISPLAY for the third time:

(4) Press DISPLAY for the fourth time:

(5) Press DISPLAY for the fifth time:

The message on the screen will be cleared.

VCD:

(1) Press DISPLAY for the first time:

TITLE 01/03 CHAPTER 002/025