PMC-Sierra PM5371 User manual

Brand
PMC-Sierra
Model
PM5371
Category
Projectors
Type
User manual

PMC-Sierra PM5371 is a monolithic, single-stage, non-blocking array of time switches for cross-connecting SONET Virtual Tributaries (VTs) or SDH Tributary UNITs (TUs). It provides non-blocking switching between two STS-3 (STM-1) byte-serial input streams and two STS-3 (STM-1) byte-serial output streams. The PM5371 operates from a single 19.44 MHz clock and provides parity checking on input data busses and parity generation on output data busses. It allows programmable idle code insertion on a per-VT or per-TU basis and permits switching of any combination of SONET VT1.

PMC-Sierra PM5371 is a monolithic, single-stage, non-blocking array of time switches for cross-connecting SONET Virtual Tributaries (VTs) or SDH Tributary UNITs (TUs). It provides non-blocking switching between two STS-3 (STM-1) byte-serial input streams and two STS-3 (STM-1) byte-serial output streams. The PM5371 operates from a single 19.44 MHz clock and provides parity checking on input data busses and parity generation on output data busses. It allows programmable idle code insertion on a per-VT or per-TU basis and permits switching of any combination of SONET VT1.

PMC-920520 (R8)
1998 PMC-Sierra, Inc. September, 1998
PM5371
PMC-Sierra,Inc.
VT/TU Cross-Connect Switch
TUDX
FEATURES
• Monolithic, SONET/SDH, single-stage,
non-blocking array of time switches for
cross-connecting SONET Virtual
Tributaries (VTs) or SDH Tributary
UNITs (TUs).
• Provides non-blocking switching
between two STS-3 (STM-1) byte-
serial input streams and two STS-3
(STM-1) byte-serial output streams.
• Operates from a single 19.44 MHz
clock.
• Provides parity checking on input data
busses and parity generation on output
data busses.
• Allows programmable idle code
insertion on a per-VT or per-TU basis.
• Permits switching of any combination
of SONET VT1.5, VT2, VT3, VT6, or
STS-1 channels. Permits switching of
any combination of SDH TU11, TU12,
TU2, or TU3 channels.
• Operates in conjunction with the
PM5362 TUPP-PLUS VT/TU Payload
Processor/Performance Monitor, which
aligns SONET VTs or SDH TUs so
they can be switched by the TUDX.
• Cascadable in a systolic or bussed
manner to allow larger switching arrays
to be implemented.
• Provides control outputs that are
programmable on a per-timeslot basis
to facilitate construction of larger
switching arrays.
• Provides a generic 8-bit
microprocessor bus interface for
configuration, control, and status
monitoring.
• Low power, +5 V, CMOS technology.
Device has TTL-compatible inputs and
outputs.
• Available in a 160-pin Plastic Quad
Flat Pack (PQFP) (28 by 28 mm)
package.
APPLICATIONS
• SONET/SDH Broadband Cross-
Connects
• SONET/SDH Add/Drop Multiplexers
• SONET/SDH Terminal Multiplexers
• SONET/SDH Test Equipment
BLOCK DIAGRAM
Input Bus
Formatter
Microprocessor
Interface
MBEB
RSTB
CS1B
RDB
WRB
ALE
A[4:0]
D[7:0]
SOUTB[8:0]
INTB
CS2B
OFP
IFP
OFSEB
SFP
SOBEB
PAGE
SCLK
DINB[8:0]
DINT[8:0]
SOUTT[8:0]
Output Bus Formatter
Switching
Element
Time
Switch
SINR[8:0]
SINL[8:0]
AOUTL[8:0]
DOUTL[8:0]
COUTL
AOBEB
ODEB
AOUTR[8:0]
DOUTR[8:0]
COUTR
Time
Switch
Switching
Element
Time
Switch
Time
Switch
Head Office:
PMC-Sierra, Inc.
#105 - 8555 Baxter Place
Burnaby, B.C. V5A 4V7
Canada
Tel: 604.415.6000
Fax: 604.415.6200
PM5371 TUDX
VT/TU Cross-Connect Switch
To order documentation,
send email to:
document@pmc-sierra.com
or contact the head office,
Attn: Document Coordinator
All product documentation is available
on our web site at:
http://www.pmc-sierra.com
For corporate information,
send email to:
[email protected]
PMC-920520 (R8)
1998 PMC-Sierra, Inc.
September 1998
TYPICAL APPLICATIONS
SYSTOLIC CROSS-CONNECT ARRAY BUSSED CROSS-CONNECT ARRAY
TRIBUTARY ALIGNMENT USING PM5362 TUPP-PLUS
∫
∫
∫
∫
∫
∫
∫
∫
∫
∫
∫
  • Page 1 1
  • Page 2 2

PMC-Sierra PM5371 User manual

Brand
PMC-Sierra
Model
PM5371
Category
Projectors
Type
User manual

PMC-Sierra PM5371 is a monolithic, single-stage, non-blocking array of time switches for cross-connecting SONET Virtual Tributaries (VTs) or SDH Tributary UNITs (TUs). It provides non-blocking switching between two STS-3 (STM-1) byte-serial input streams and two STS-3 (STM-1) byte-serial output streams. The PM5371 operates from a single 19.44 MHz clock and provides parity checking on input data busses and parity generation on output data busses. It allows programmable idle code insertion on a per-VT or per-TU basis and permits switching of any combination of SONET VT1.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents