Evenflo Symmetry User manual

25701021 11/15

Symmetry

™

High Chair

Chaise haute

Silla alta

Up to 40 lbs

Jusqu'à 18,0 kg

Hasta 18,0 kg

High Chair

Chaise haute

Silla alta

Read all instructions before assembly and use of product.

KEEP INSTRUCTIONS FOR FUTURE USE.

Lire les instructions avant l’assemblage et l’utilisation du produit.

CONSERVER CES INSTRUCTIONS POUR RÉFÉRENCE ULTÉRIEURE.

Lea las instrucciones antes de armar y usar el producto.

GUARDE ESTAS INSTRUCCIONES PARA REFERENCIA FUTURA

.

1

READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS!

FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY OR DEATH!

• NEVER leave child unattended. ALWAYS keep child in view while in the high chair.

• Adult assembly required. Take care when unpacking and assembling; contains small parts and sharp edges.

• To prevent a possible choking hazard, remove and discard packing material before using this product.

• Prevent serious injury or death from falls or sliding out:

The child should be secured in the high chair at all times by the restraining system, either in the reclined or upright

position. The tray is not designed to hold the child in the chair. It is recommended that the high chair be used in

the upright position only by children capable of sitting upright unassisted.

• DO NOT use high chair with children who weigh more than 40 lbs (18 kg).

• ALWAYS secure child with the restraining system.

• DO NOT use high chair if it is broken in any manner or parts are missing.

• NEVER move the high chair while it is occupied.

• NEVER adjust the seat back while baby is in the high chair.

• Care must be taken when folding or unfolding the high chair to prevent ﬁnger injury in hinge areas.

• Care must be taken when transporting the high chair to avoid injury due to unexpected unfolding.

• DO NOT allow child to climb in or out of high chair unassisted.

• DO NOT use on an uneven surface.

• MAKE SURE product is completely assembled before using.

• To avoid high chair instability and tip-overs, DO NOT load rear storage area with over 2 lbs (0.9 kg).

WARNINGS

TABLE OF CONTENTS

Warnings ....................................................................................................... Below

Important Information ................................................................................... Below

Assembly Parts Identification ...................................................................................1

Assemble the High Chair ........................................................................................ 2

Adjusting the Tray .................................................................................................. 3

Recline Adjustment ................................................................................................. 4

Using the Restraining System ................................................................................. 4

Folding the High Chair ........................................................................................... 5

Changing Shoulder Strap Position .......................................................................... 6

Changing the Padded Seat Cover ............................................................................6

Care and Maintenance ............................................................................................7

Limited Warranty ....................................................................................................7

ASSEMBLY PARTS IDENTIFICATION

To order replacement parts you can order online at www.evenflo.com or call 1-800-233-5921. When you contact us, please

have the product model number and date of manufacture.

IMPORTANT INFORMATION

• www.evenflo.com • USA: 1-800-233-5921, 8 AM – 5 PM E.T.

• Canada: 1-937-773-3971 • México: 01-800-706-12-00

Registration Information

Please register this product so we can reach you if there is a safety alert or recall. We will not sell, rent, or share your

personal information. To register your product, please complete and mail the card that came with it or visit our on-line

registration at www.evenflo.com/registerproduct.

For future reference, record the Model Number and Date of Manufacture, which can be found on the back or bottom of the

high chair.

Model Number: Date of Manufacture:

Read instructions carefully before use. Save these instructions for future reference. It is very important to assemble the high

chair according to these instructions. DO NOT USE YOUR HIGH CHAIR UNTIL YOU READ AND UNDERSTAND

THESE INSTRUCTIONS.

If you are missing parts, do not use the high chair and call Evenflo ParentLink at 1-800-233-5921 (U.S.A.),

1-937-773-3971 (Canada), or 01-800-706-12-00 (Mexico) to order replacement parts.

Back Leg

Tray Assembly

Tray Liner

(On some models)

Front Leg

High Chair

Harness Covers

(On some models)

WARNING

32

1

2

5

You should not see any red on the leg tubes when the seat is

securely locked into the open position.

Rotate footrest down until it clicks onto the bar beneath it.

Pull tabs E outward on both sides of tray. Slide tray into the

channels on each armrest of the high chair until it locks into

one of the three tray positions.

If the tray is NOT LOCKED onto the high chair, the

WARNING symbol will be visible as shown.

Pull on tray to make sure it is locked in place.

To adjust the tray, pull tabs outward on both sides of the tray

and slide the tray into one of the three tray positions.

Pull on tray to make sure it is locked in place.

LOCKED NOT LOCKED

Lay the high chair face down and install the front wheel tube

assembly A onto the front legs B, as shown.

Make sure the front wheel tube assembly locks onto both

front legs with an audible click on each side.

Pull on the front wheel tube assembly A to make sure it is

attached securely.

Install the back foot tube assembly C onto the back legs D, as

shown.

Make sure the back foot tube assembly locks onto both back

legs with an audible click on each side.

Pull on the back foot tube assembly C to make sure it is

attached securely.

6

ASSEMBLE THE HIGH CHAIR

ADJUSTING THE TRAY

4

Keep one hand on the handle and one foot on the frame

while pulling up on the top of the seat until the bottom on

both sides of the high chair lock into place with an audible

click.

Press down on both tray arms to make sure the frame is

securely locked into position.

1

2

3

1

2

3

B

A

LOCKED NOT LOCKED

D

C

To protect flooring, place a protective covering (cardboard,

towel, small rug or blanket) beneath the high chair during

assembly.

WARNING

Care must be taken when folding or unfolding the

high chair to prevent finger injury in hinge areas.

E

54

To recline seat, lift handle and rotate seat back.

To fold high chair, push buttons on both sides of the high

chair next to the handles.

Step on middle of the back tube assembly and pull up on

handles while seat slides down into folded position.

High chair will stand on its own when folded.

To raise seat, push seat up.

RECLINE ADJUSTMENT

FOLDING THE HIGH CHAIR

B

C

3-pt Restraint

5-pt Restraint

A

Place the baby in the seat and bring the crotch strap A up between the child’s legs. Fasten each buckle B and

pull the straps to tighten the waist restraint for a snug fit.

Note: To loosen straps, push in the release button C on the buckle and pull upward.

• The child MUST be secured in the high chair at all times by the restraining system.

The tray is not designed to hold the child in the chair.

• NEVER leave child unattended.

USING THE RESTRAINING SYSTEM

• The child should be secured in the high chair at all times

by the restraining system, either in the reclined or upright

position. The tray is not designed to hold the child in the

chair. It is recommended that the high chair be used in the

upright position only by children capable of sitting upright

unassisted.

• Never adjust the seat back while baby is in the high chair.

WARNING

1

2

3

WARNING

Care must be taken when folding or unfolding the

high chair to prevent finger injury in hinge areas.

WARNING

Care must be taken when transporting the high

chair to avoid injury due to unexpected unfolding.

76

CHANGING SHOULDER STRAP POSITION

To change shoulder strap position, remove one shoulder strap

A, at a time, then insert it in the appropriate slot nearest

the top of the child’s shoulders B. Make sure the shoulder

strap anchor C is completely through the slot, then pull the

shoulder strap to make sure it is attached securely. Repeat for

the other shoulder strap.

To remove the padded seat cover A, first remove the harness

from the padded seat cover. Push the waist restraint strap

back through the buckles B. Push the shoulder straps

through the padded seat cover from the back. Push the

crotch strap through the padded seat cover from the bottom.

Unfasten snaps and Velcro

®

strips C, and remove the padded

seat cover A to wash or replace.

To install padded seat cover, place it over the top of the seat

back. Fasten the snaps and Velcro

®

strips C. Insert the end of

the crotch strap through the slot in the bottom of the padded

seat cover, then pull the crotch strap upward to make sure it

is attached securely. Replace the shoulder straps, as described

above.

CHANGING THE PADDED SEAT COVER

• Check screws periodically for tightness.

• Wipe metal and plastic parts with a soft damp cloth and dry with a soft cloth. DO NOT use abrasive cleaners or solvents. Do not

clean any part of the high chair in the dishwasher except the tray liner.

• TO CLEAN THE TRAY: Wash tray with mild soap and warm water and dry thoroughly before using. Do not immerse in water.

Do not wash tray in dishwasher. Only the tray liner is dishwasher-safe (top rack only).

• TO REMOVE THE PADDED SEAT COVER: Release all buckles of the waist restraint. Push the restraints through the slits in the

pad. Unfasten snaps and Velcro

®

strips. Pull the back of the padded seat cover off the back of the seat.

• TO CLEAN CLOTH PAD: Clean cloth surfaces with cold water, mild soap and a soft brush. Air dry.

• TO CLEAN THE WAIST RESTRAINT: Wash by hand in cool water – NO BLEACH. Allow to air dry.

CARE AND MAINTENANCE

For a period of 90 days from the original purchase of this Product, Evenflo warrants to the original end user (“Purchaser”)

this Product (including any accessories) against defects in material or workmanship. Evenflo’s sole obligation under this

express limited warranty shall be, at Evenflo’s option, to repair or replace any Product that is determined to be defective by

Evenflo and determined to be covered by this warranty.

Repair or replacement as provided under this warranty is the exclusive remedy of the Purchaser. Proof of purchase in the

form of a receipted invoice or bill of sale evidencing that the Product is within the warranty period must be presented to

obtain warranty service. This express limited warranty is extended by Evenflo ONLY to the original Purchaser of the Product

and is not assignable or transferable to subsequent purchasers or end users of the Product. For warranty service, contact

ParentLink Consumer Resource Center at (800) 233-5921 or www.evenflo.com.

EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS

FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS HEREBY DISCLAIMED. EVENFLO SHALL NOT BE LIABLE FOR ANY INCI-

DENTAL, CONSEQUENTIAL, SPECIAL OR PUNITIVE DAMAGES OF ANY KIND FOR BREACH OF THE EXPRESS LIMITED WAR-

RANTY ON THIS PRODUCT, OR ANY WARRANTY IMPLIED BY OPERATION OF LAW. OTHER THAN THE EXPRESS LIMITED

WARRANTY SET FORTH ABOVE, THERE ARE NO OTHER WARRANTIES THAT ACCOMPANY THIS PRODUCT AND ANY ORAL,

WRITTEN OR ANY OTHER EXPRESS REPRESENTATION OF ANY KIND IS HEREBY DISCLAIMED.

LIMITED WARRANTY

• www.evenflo.com • USA: 1-800-233-5921, 8 AM – 5 PM E.T.

• Canada: 1-937-773-3971 • México: 01-800-706-12-00

B

A

C

A

B

C

B

Page is loading ...

Evenflo Symmetry User manual

Evenflo Symmetry User manual

in other languages

Related papers

Other documents