DURO FLEX D3D30R250 Operating instructions

Type
Operating instructions

This manual is also suitable for

Instructions - Assembly Duroflex 3D
Steps to install Duroflex 3D in chimneys:
1. Ensure application area is clean and dry.
2. Place Duroflex 3D into position and form it to basic shape of roof.
3. Remove the protective film and firmly fix top butyl adhesive into
place.
4. Repeat operation in both sides of the chimney.
5. Mold to the chimney using a rubber hammer.
6. Place tiles over Duroflex 3D to create a watertight seal against the
roof.
7. Mold to the chimney using a rubber hammer.
8. Screw the aluminum profiles and seal.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

DURO FLEX D3D30R250 Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI