SAFETY TRAINING INFORMATION
Warning: Please Read Carefully
A transceiver generates RF (Radio Frequency) electromagnetic energy while transmitting. This Alinco
transceiver is designed for and classied as “Occupational Use Only”, meaning it must be used minimum
necessary only during the course of employment by employees aware of the hazards, and the ways
to minimize such hazards. This transceiver is not intended for use by the “General Population” in an
uncontrolled environment. This transceiver has been required “SAR-Standard” tested and complies with
the FCC RF exposure limits for “Occupational Use Only”.
To ensure that your expose to RF electromagnetic energy is within the allowable limits for occupational
use, always adhere to the following guidelines:
•
DO NOT operate the transceiver without a proper antenna attached, as it may damage the transceiver
and may also cause you to exceed FCC RF exposure limits. A proper antenna is the genuine antenna
supplied with this transceiver by Alinco or ones specically authorized by the antenna manufacturer for
use with this transceiver.
•
ALWAYS keep the antenna at least 3cm (1 inch) away from your body when transmitting and only use
the original belt clips when attaching the transceiver to your body (Unauthorized attachment devices may
help radiating more electromagnetic energy). To obtain the best sound quality during communications,
hold the antenna at least 6cm (2 inches) from your mouth, and slightly off to one side.
•
Use only the genuine Alinco accessories listed in this instruction manual for RF safety. Third party
accessories are not guaranteed for RF safety by Alinco.
•
Electromagnetic Interference/Compatibility
During transmissions, a transceiver generates RF energy that can possibly cause interference with other
devices and/or systems.