Before attempting the connection,
check whether the voltage indicated
on the rating plate corresponds to
the actual mains voltage.
Mains lead should be minimum1.5m
long.
Earth wire should be installed in
such manner to be the last one pulled
out in case the safety device of
the mains lead should fail.
Mains lead behind the oven must be
placed in such a manner to avoid
touching the back panel of the oven
because of the heat it develops
during operation.
Cable correct size rating please
oven
CONNECTION DIAGRAM
Caution! Voltage of heating elements 220-240V
Caution! In the event of any connection the safety
Wire must be connected to the
E terminal.
Recommended
type of
connection
lead
1
For 220-240V earthed one-phase
connection, bridges connect 1-2-3
terminals and 4-5 terminals, safety
wire to
L
N
PE
H05VV-F3G4
L=R, N=earth terminal, PE=safety wire terminal
1
2 3
4
.
The connection cable must be secured in a strain
-
relief clamp.For the connection leads,
the earth wire must be longer than the other wires.
Caution!
Remember to connect the safety circuit to the connection box terminal marked with
. The
electricity supply for the oven must have an all-pole disconnection switch which enab-
les the power to be cut off in case of emergency. The distance between the working
contacts of the safety switch must be at least 3 mm.
Before connecting the oven to the power supply it is important to read the information on
the manual.
follow the below diagram.
10
11
Control Panels