2. Computers & electronics
  3. TVs & monitors
  4. Wall & ceiling mounts accessories
  5. Chore-Time
  6. MV1738A TURBO-COOL™ Sump Inlet Repair Kit

Chore-Time MV1738A TURBO-COOL™ Sump Inlet Repair Kit Operating instructions

  • Hello! I am an AI chatbot trained to assist you with the Chore-Time MV1738A TURBO-COOL™ Sump Inlet Repair Kit Operating instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Thank You
The employees of Chore-Time Equipment would like to thank your for your recent Chore-Time purchase. If a
problem should arise, your Chore-Time distributor can supply the necessary information to help you.
Turn off the water supply and remove the supply hose.
If possible, mark the position of the Water Inlet Pipe to make it easier for resetting float height after installation of
the new Inlet Pipe Support Bracket.
Remove the Stainless Steel Hose Clamp.
Using a Utility Knife, remove the old Spinweld Fitting (Item 1, Figure 1). Be careful not to cut deep enough to
damage the Inlet Pipe. (Item 2)
Place the Inlet Pipe Support Bracket (Item 1, Figure 2) over the Inlet Pipe (Item 2). Wrap the Stainless Steel Hose
Clamp around the Inlet Pipe and through the slots in the back of the Inlet Pipe Support Bracket (Item 3) as shown.
Turbo-Cool™ Sump Inlet Repair Kit (48202)
Instruction
Installation
Item Description
1 Spinweld Fitting
2 Inlet Pipe
2
1
Figure 1. Removing Spinweld Fitting
1
2
3
Slots in Inlet Pipe Support Bracket
Item Description
1 Inlet Pipe Support Bracket
2 Inlet Pipe
3 SS Hose Clamp
Figure 2. Inlet Pipe Support Installation
MV1738A
September 2003
Installation Turbo-Cool™ Sump Inlet Repair Kit (48202) Instruction
2
MV1738A
Using the holes in the Inlet Pipe Support Bracket for a guide, Drill four 1/4" holes in the Sump (See Figure 3 below).
Use the supplied Bolts, Nuts and Washers to secure the Inlet Pipe Support Bracket to the Sump.
Once the Inlet Pipe is in the proper position tighten down the Stainless Steel Hose Clamp. Make sure the Float Ball
moves freely. Reconnect the hose and reset the Water Inlet Pipe to it’s original position. Turn on the water supply.
See Turbo-Cool Manual for setting water level height.
CTB Inc.
P.O. Box 2000 • Milford, Indiana 46542-2000 • U.S.A.
Phone (574) 658-4101 • Fax (877) 730-8825
E-Mail: [email protected] • Internet: http//www.ctbinc.com
Printed in the U.S.A.
Item Description
1 Inlet Pipe Support Bracket
2 Sump
3 Bolt
4 Washer
5 Nut
5
1
3
2
4
Figure 3. Inlet Pipe Support Installation
/