DVL Insert Ledgestone Firebacks
96100276
Page 1 of 3 17601914 - 1/11/16 Travis Industries, Inc.
Compatibility
These firebacks are only compatibility with DVL Inserts with Emberfyre Burners
(not compatible with 33 DVI Inserts or DVL Inserts with Dancingfyre Burners)
These firebacks are only compatible with DVL inserts using Emberfyre burners built after October, 2015.
These burner kits include a rear log with a cavity in the back (see pictures below). This cavity allows for the
new accent light bracket (see illustration below). To use this kit on a DVL Insert you must have the new
rear log and new bracket.
Old Rear Log
New Rear Log (250-03525)
Note this cavity in the center
Old Bracket
New Bracket
(250-03747)
Packing List
Rear Fireback
Right and Left Side Firebacks
Fireback Orientation
Make sure the firebacks are oriented as shown below (the stone lines and coloring will line
up). Arrange the firebacks before installing to verify alignment.
Note how these notches fit with the adjoining fireback.
DVL Insert Ledgestone Firebacks
96100276
Page 2 of 3 17601914 - 1/11/16 Travis Industries, Inc.
Installation
WARNING Turn off gas to the appliance and make sure it has fully cooled prior to conducting service.
1 Remove the glass frame and logs (see the manual for details).
DVL Inserts with Emberfyre Burner
When using the DVL insert with Emberfyre burner, the accent light will need to be moved aside when
installing the rear fireback. Remove the burner and bend the accent light bracket down. After the firebacks
are in place, bend the light bracket upright and replace the burner.
2 Install the rear fireback as shown below. The top slides behind the baffle and the bottom rests on the shelf at
the back of the firebox.
Slide the back fireback
behind the baffle on top
of the firebox then pivot it
into place. It rests on the
shelf at the back of the
firebox.
Handmade Brick (96100274) - Mortar Line at Top
Standard Brick (96100150) - Mortar Line at Bottom
Make sure the fireback is positioned correctly
(
see pa
g
e 1
)
.
DVL Insert Ledgestone Firebacks
96100276
Page 3 of 3 17601914 - 1/11/16 Travis Industries, Inc.
3 Install the side firebacks following the directions below.
Hold the side firebacks at a slight angle
and place them into position (both
sides).
Remove this clip
attached to the firebox
ceiling (both sides).
Replace the clip to
secure the side
fireback (both sides).
The side fireback clip
has a keyhole slot. It
can be removed by
loosening the screw
and sliding the clip out.
4 Restore the appliance to the correct configuration.
/
