Delta Electronics Digital Keypad VFD-PU06 User manual

Type
User manual

This manual is also suitable for

2007-07-19
5011615002-U6E2
VFD-PU06
Digital Keypad Instruction Sheet
X Description of the Digital keypad VFD-PU06
U
F
H
VFD-PU06
JOG
RUN
RESET
STOP
LED Display
Indicates frequency, voltage, current, user
defined units, read, and save, etc.
Status Display
Display the driver's current status.
Model Number
STOP/RESET
Stops AC drive operation and reset the drive
after fault occurred.
PU
EXT PU
Right key
Move the cursor to the right
RUN Key
Start AC drive operation.
Frequency Command
Status indicator
Output Frequency
Status indicator
User Defined Units
Status indicator
JOG
By pressing JOG key,
Jog frequency operation.
MODE
Change between different display mode.
Left Key
Move cursor to the left.
UP and DOWN Key
Set the parameter number
and changes the numerical
data, such as Master Frequency.
FWD/REV Key
Select FWD/REV operation.
Y Explanation of Display Message
Display Message Descriptions
The AC motor drive Master Frequency Command.
The Actual Operation Frequency present at terminals U, V, and W.
The custom unit (u)
The output current present at terminals U, V, and W.
Press
to change the mode to READ. Press PROG/DATA for about 2
sec or until it’s flashing, read the parameters of AC drive to the digital keypad
PU06. It can read 4 groups of parameters to PU06. (read 0 - read 3)
Press
to change the mode to SAVE. Press PROG/DATA for about 2 sec
or until it’s flashing, then write the parameters from the digital keypad PU06 to
AC drive. If it has saved, it will show the type of AC motor drive.
The specified parameter setting.
The actual value stored in the specified parameter.
Display Message Descriptions
External Fault
“End” displays for approximately 1 second if the entered input data have been
accepted. After a parameter value has been set, the new value is automatically
stored in memory. To modify an entry, use the
or keys.
“Err” displays if the input is invalid.
Communication Error. Please check the AC motor drive user manual (Chapter
5, Group 9 Communication Parameter) for more details.
Z Operation Flow Chart
XX
XX-XX
XXXXX
-END-
VFD-PU06 Operation Flow Chart
Program
Error
-ERR-
Or
Program
Successful
Press UP key to select
SAVE or READ.
Press PROG/DATA for
about 2 seconds or until
it is flashing, then save
parameters
or read parameters
.
from PU06 to
AC drive
from AC drive to PU06
  • Page 1 1
  • Page 2 2

Delta Electronics Digital Keypad VFD-PU06 User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI