CTC Union IMC-100 Quick Installation Manual

Brand: CTC Union

Model: IMC-100

Category: Network media converters

Type: Quick Installation Manual

This manual is also suitable for

CTC Union IMC-100-E is a rugged industrial-grade Fast Ethernet media converter designed for harsh environments. It supports conversion between electrical 10/100Base-TX and optical 100Base-FX Ethernet, making it suitable for applications such as industrial networking, intelligent transportation systems, and military/utility markets. With its wide temperature range (-40°C to 75°C), IP30-rated metal housing, and redundant dual DC inputs (12/24/48VDC), the IMC-100-E can withstand harsh conditions and ensure reliable connectivity.



CTCUnionTechnologiesCo.,Ltd.

FarEasternViennaTechnologyCenter

(NeihuTechnologyPark)

8F,No.60ZhouziSt.,NeihuDistrict,Taipei114

Taiwan



T+886‐2‐26591021

F+886‐2‐26590237

E[email protected]



Alltrademarksarethepropertyoftheirrespectiveowners.

Technicalinformationinthisdocumentissubjecttochangewithoutnotice.



Introduction

IMC‐100isafamilyofFastEthernetmediaconverters that

supportconversionbetweenelectrical10/100Base‐TXandoptical

100Base‐FXEthernet.HousedinruggedDINrailorwall

mountableenclosures,theseconvertersaredesignedforharsh

environments,suchasindustrialnetworkingandintelligent

transportationsystems(ITS)andarealsosuitableformany

militaryandutilitymarketapplicationswhereenvironmental

conditionsexceedcommercialproductspecifications.



Features

• RedundantdualDCinputs12/24/48VDC

• IP30ruggedmetalhousing

• Widetemperaturerange‐40~75C(100‐E,100‐PDE)

• IndustrialgradeEMScertification

• Switch/convertermodesetting

• UL508,CE,FCC,EN50121‐4Railtraffic



Specifications

OpticalInterface

• 100Base‐FX

• OptionsforSCorSTconnectors

• Multimode(2km)50/125um,62.5/125um

• Singlemode(30or50km)9/125um

• Wavelength:1310nm(S/MorM/M)

• BiDioption(20km)forSinglemodesinglefiber



EthernetInterface

• Connector:RJ‐45(shielded)

• AutoMDI/MDI‐X

• Speed:10/100Base‐TX(Auto/ForcedbyDIP)

• Duplex:Full/Half(Auto/ForcedbyDIP)

• FlowControl:802.3x(enablebyDIP)

• Store&ForwardSwitch/Cutthroughconverter(byDIP)

• Standards:IEEE802.3,802.3u,802.3x,802.3af(PD)

• 1024MACtable(inswitchmode)

• MTU:2046bytes(switch)/9600bytes(converter)

• LinkFaultPassThrough(LFP)enable/disable(byDIP)



QuickInstallationGuide



IMC‐100

IMC‐100‐E

IMC‐100‐PD

IMC‐100‐PD‐E

IndustrialGradeFastEthernetMediaConverters



TodownloadthisQIGoramorecompleteusermanual,pleasevisit

http://www.ctcu.com/Industrial/



[email protected]



Specifications(cont.)

Power

• Absoluterange:9.6~58VDC

• Reversepolarityprotection:Yes

• Dualpowerinputs:Yes

• Connector:terminalblock

• Consumption:2.9W



Mechanical

• Water&DustProof:IP30Protection

• Dimensions:106x39x142mm(DxWxH)

• Mounting:DIN‐Rail,WallMount(kitsincluded)

• Weight:720g(1.5lb)



Environmental

• OperatingTemperature:

• 0°C~60°C,‐40°C~75°C(widetemp.for*‐E)

• StorageTemperature:‐40°C~85°C

• Humidity:5~95%(non‐condensing)



Certifications

• EMI:(ElectromagneticInterference)

• EN61000‐6‐4Emissionforindustrialenvironment

• FCCPart15subBclassA,EN55022ClassA

• EMS:(ElectromagneticSusceptibility)

• EN61000‐6‐2Immunityforindustrialenvironment

• EN61000‐4‐2(ESD)Level3,CriteriaB

• EN61000‐4‐3(RS)Level3,CriteriaA

• EN61000‐4‐4(Burst)Level3,CriteriaA

• EN61000‐4‐5(Surge)Level3,CriteriaB

• EN61000‐4‐6(CS)Level3,CriteriaA

• EN61000‐4‐8(MagneticField)Level3,CriteriaA

• Safety:UL508(pending)

• RailwayTraffic:EN50121‐4

• Shock:EN60068‐2‐27

• Freefall:EN60068‐2‐32

• Vibration:EN60068‐2‐6

• MTBF:852,727hours



[email protected] www.ctcu.com V1.2

 

Connectors OperationModeSwitch

 IMC‐100usesa6‐poleDIPswitchforconfiguration.

 

IMC‐100 Eachpoleoftheswitchhasthefollowingfunctions:

 

IMC‐100hasfixedopticaltransceiveroptionsforconnector

typesofSTorSC.TheLANconnectionusesashieldedRJ‐45which

supportsAutoMDI/MDI‐X.Configurationsettingsare

accomplishedviaa6‐poleDIP(dualinlinepackage)switch.Please

seethenextpageforthesettingsoftheoperationmodeswitch.

1.Auto/Forced:When'On'thisswitchwilldisabletheNwayauto‐

negotiationoftheTPport,placingitinmanualforcedmode.The

nexttwoswitchesthenaffectthespeedandduplexofthemanual

configuration.



 2.10/100:When'On'thisswitchwillforcetheTPportspeedto

10M.'Off'willforcethespeedofTPportto100M.Inorderto

forcethespeed,switch1mustbe'On'.

Power&Alarm



 

3.Half/Full:When'On',thisswitchwillforcetheTPporttoHalf

Duplex.When'Off',thisswitchwillforcetheTPporttoFull

Duplex.Inordertoforcetheduplex,switch1mustbe'On'.





4.LFP:LinkFaultPassthroughallowsalinkconditiontobepassed

fromfibertoTPorfromTPtofiber.ToenableLFP,placethis

switchinthe'On'position. LFP is onlyavailablewhenthemedia

converterissetto'Switch'mode(Sw6‐Off)andsetfor'Auto'

negotiation(Sw1‐Off).



Aremovableterminalblockprovidesbothpowerandalarm

connections.Powercanbeprovidedthroughthedualinputsfrom

separatesources.Oneelectricalrelaycanbewiredinto analarm

circuit.Fromthecommonpin(COM),therelaycanbeconnected

asNormallyOpen(NO)orNormallyClosed(NC).Thealarmis

triggeredintheeventofeitherlinklossforopticalorelectricalor

both.



5.FlowControl:IEEE802.3xisthestandardforEthernetflow

control.Toenableflowcontrolinthisconverter,placeswitchto

the'On'position.



 6.Mode:When'Off',thisunitactsasastore&forwarddevice

supportingMAClearningandfilteringwithMTUof2046bytes.

When'On'theunitactsaspure'converter'.Theinternalswitchis

bypassed,enablinglowlatencyandjumboframesupport.Donot

enableLFPinthismodeorfibermaynotlink.

PoEPowered

WhenIMC‐100‐PDunitisbeingpoweredfromPoEsource,the

unitwillbeentirelypoweredbyPoEandnopowertakenfromthe

PWR1orPWR2inputs.IfPoEsourceshouldfail,theunitwill

automaticallyswitchtousingpowerfromthePWR1andPWR2

DCsourceconnections,ifavailable.



 

LEDIndicators Installation

IMC‐100andIMC‐100‐PDhaveLEDsonthefrontfacethat

reporttheconditionofpower,Fiberlink,LANlink,speedand

availabilityofPoEpower(PDmodel).

IMC‐100comeswithbothwallmountandDINrailhardware

brackets.WheninstallingtheDINrailbracket,besuretocorrectly

aligntheorientationpin.

 

 IMC‐100  IMC‐100‐PD 

 

PWR1:ThisgreenLEDwilllightifpowerisconnectedandactive

atthePWR1terminalconnection.



 DINRailWallMount

PWR2:ThisgreenLEDwilllightifpowerisconnectedandactive

atthePWR2terminalconnection.



 IMC‐100withDINRailbrackethasasteelspringintheupperrail

ofthebracket.Thisspringiscompressedformountingandun‐

mountingbyapplyingdownwardforce.

Fault:ThisredLEDwilllightifthefiberorTPhaveanyfault

condition.



Fiber:ThisgreenLEDwilllightwhenthefiberporthasanoptical

linkandflashwhenthereisdatatraffic.



 

100:ThisamberLEDwilllightwhentheLANconnectedspeedis

100M.



 

LAN:ThisgreenLEDwilllightwhentheLANporthasalinkand

willflashwhenthereisEthernettraffic.



 

PoE:IMC‐100‐PDisaPoEPD(powerdevice)which isabletosink

powerfromaPSE(PowerSourceEquipment)overEthernetcable.

ThisgreenLEDislitwhentheLANisconnectedtoanactivePSE

(powersourceequipment)suchasPoEcapableswitch.Powercan

becompletelyprovidedoverEthernetwithoutanyconnectionsto

PWR1orPWR2.Additionally,ifPWR1andPWR2areconnected,

theywillactasahotbackupincaseofPoEsourcefailure.



 



mountingun‐mounting

[email protected] www.ctcu.com

CTC Union IMC-100 Quick Installation Manual

Brand: CTC Union

Model: IMC-100

Category: Network media converters

Type: Quick Installation Manual

This manual is also suitable for

Download PDF

report

CTC Union IMC-100 Quick Installation Manual

This manual is also suitable for

CTC Union IMC-100 Quick Installation Manual

Related papers

Other documents