PowerStroke PS142012-DISP Owner's manual

PS142012-DISP Assembly Instructions

Tools Needed:

Phillips Screwdriver 10 mm Wrench

Step 1.

Install the wheels.

Step 2.

Install the handle using the 10 mm

wrench and Phillips screwdriver to

tighten nut and bolt.

Step 3.

Install the nozzle storage panel using

Phillips screwdriver and screws.

Step 4.

Install trigger handle holder using

Phillips screwdriver and screw.

Step 5.

Assemble trigger handle and wand.

Twist the wand into the front of the

trigger handle.

Step 6.

Place trigger handle into bracket and

secure with cable tie.

Step 7.

Place the nozzles into the holes on the

storage panel.

PN: 995000434

AXLE

HITCH PIN

NUTS

BOLTS

SCREW

CABLE

TIE

Step 8.

Coil the high pressure hose and place

over the metal bracket on the back

of the nozzle storage panel as shown

below.

SCREWS