2. Dahua
  3. NVR5216-16P-1
NVR5216-16P-1

Dahua NVR5216-16P-1 User guide

  • Hello! I've reviewed the user guide for Dahua's NVR System, focusing on setting up Linkage Actions. This guide provides instructions on how to configure PTZ camera movements, email alerts, and snapshot captures when an alarm is triggered. I understand the steps for setting up IVS triggers, motion detection and schedules for snapshot recording. I'm ready to assist with your questions about this device and it's capabilities.
  • What actions can be linked to an alarm event?
    How do I set up PTZ action for an alarm event?
    How do I set up snapshot recording for motion detection?
The following guide enables you to set up the Linkage Action Function on
(Series 3) and (Series 5 & 7) NVR-systems.
How to set the Linkage Action when the alarm occurs, like
PTZ action, e-mailing & snapshot
TiOC HOW TO GUIDE
NB: The firmware version is based on the latest version when this
document was created and may slightly differ from future versions,
however this will not affect any of the functionality.
For an NVR-system
Series Example
NVR5000-1 Series NVR5216-16P-1
Here we’ve used IVS as an example:
Step 1: PTZ action and e-mailing
Go to AI > ”PARAMETERS” > ”IVS”, choose the channel you want to link with PTZ action
and e-mailing, keep it Enabled and click Trigger icon.
TiOC HOW TO GUIDE | How to set the Linkage Action Function, like PTZ action, e-mailing & snapshot
1
2
Figure 2: Click �Trigger� to set PTZ action and e-mailing
3
4
5
Figure 1: Start from the setup page of the NVR
TiOC HOW TO GUIDE | How to set the Linkage Action Function, like PTZ action, e-mailing & snapshot TiOC HOW TO GUIDE | How to set the Linkage Action Function, like PTZ action, e-mailing & snapshot
Step 2: Activate the function Send Email and/or click the function PTZ Linkage.
Click Apply to save your settings.
For Snapshot
Set the record: If you want to record motion detection, go to “Storage” > “Schedule”,
ensure the tab is set to Snapshot , check the channel is the one you want to set, and
click Settings.
Figure 4: Start from the setup page of the NVR
3
Figure 3: Trigger settings
1
2
1
TiOC HOW TO GUIDE | How to set the Linkage Action Function, like PTZ action, e-mailing & snapshot
If you still encounter problems
operating your Dahua device,
please call +44 (0)1628 613 500
*
Design and specications are subject to change without notice.
DAHUA UK & IRELAND
Quantum, 60 Norden Road, Maidenhead, Berkshire SL6 4AY
Tel: +44 (0) 1628 613 500
[email protected]
[email protected]
On this page you can choose what kind of record can be stored. An example of
“General” and “Motion Detection” are shown below.
Choose the day you want to record the event for motion detection, then click OK to
save your settings.
Figure 6: Setting the snapshot record time
1
2
Figure 5: Setting the snapshot channel
24
3
5
/