2. CABINET
  3. INSTANT 2-4 Cable Method Switching

CABINET INSTANT 2-4 Cable Method Switching Operating instructions

  • Hello! I've reviewed the user manual for the OTS1 Patch-Box by AXESS Electronics. This device allows for instant switching between 2 and 4 cable method setups, automatically re-routing your FX loop pedals. It also features multi-pin DIN footswitch compatibility. I'm ready to answer any questions you have about it.
  • What does the 4CM/2CM button do?
    What happens when I select the 2CM position?
    Will my pedalboard connections change when switching between 2CM and 4CM?
INSTANT 2 ⬌ 4 CABLE METHOD SWITCHING AND MULTI-PIN DIN FOOTSWITCH
Doc. OTS1-DIN8-01
©2022 AXESS ElectronicsTM | AXSGTRTM
Rev. 2022-10-30
** 2CM!
or 4CM
** 2CM: No Cbl/Loop / 4CM: SEND
** 2CM: No Cbl/Loop / 4CM: RTRN
7-PIN DIN"
FOOT-SW
PEDALS IN FRONT
POWER ON
OTs1 PATCH-BOX
axsGTR
TO AMP IN
TRS THRU
TO RTRN
S-R/TRS
FROM SEND
FROM GUITAR
BUF/BYP
4CM/2CM
S
6
3
2
1
5
4
7
8
DIN THRU
9VDC
OTs1 PATCH-BOX
FROM LP-FX
TRS THRU
TO LP-FX
TO GT-FX
FROM GT-FX
S
6
3
2
1
5
4
7
8
DIN THRU
axsGTR
12345
PH-5C
TIME BASED EFFECTS
** 2CM: AFTER THE OVERDRIVE
4CM: IN THE AMP’S FX LOOP
** Instantly re-route the FX LOOP pedals into
the front of the amplifier, when substituting an
amp with an effects loop (4CM) for one without
(2CM), by pressing the 4CM/2CM button and
selecting the 2CM position. All of the pedals
and all of the pedalboard connections remain
unchanged! All of the necessary signal path
changes are taken care of by/within the OTS1
Patch-Box, automatically.
IN
/